FRIGIDAIRE Packac Air Conditioner Feai
This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.
Product Registration Record Your Hodei and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Model No, Serial No Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company.
Air Conditioner Features ELECTRONIC CONTROL Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the touch pad alone or with the remote.
Operating Instructions (continued) TO CHANGE TEMPERATURE SETTING: YOU WILL SEE: DO THIS: PRESSTO RAISE PRESSTO LOWER Note: Tap or hold either up (A) or down ( v ) button until the desired temperature is seen on the display. This temperature will be automatically maintained anywhere between 60 °F (16 °C) and 90 °F (32 °C) for cooling mode. The temperature will be automatically maintained anywhere between 55 °F (13 °C) and 80 °F (27 °C) for heating mode.
Operating Instructions (continued) TO OPERATE ON FAN ONLY: YOU WILL SEE: LIGHT ON DO THIS; PRESS MODE BUTTON CHOOSE FAN ONLY Note: Use this function (Remember only when cooling to open the vent during is not desired, this function, such as for room but keep it closed choose any fan speed you prefer. (Except "Auto Fan"). During this function, the display will show the actual room cannot be selected when the unit is in the "Remote temperature, Sensing" mode.
Operating Instructions (continued) CHECK FILTER FEATURE: YOU WILL LIGHT ON SEE: LIGHT OFF DO THIS: PRESS CHECK FILTER BUTTON i ( .................. Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Check Filter" CLEAN AIR FEATURE(on YOU WILL some models): operation. The LED (light) will button and the light will go off.
Operating Instructions (continued) REMOTE SENSING FEATURE (on some models). LIGHT pulsi ( On & Off intermittently ).
Instructions Operating (continued) FAULT CODES: i:i¸ If the display reads "HS", a sensor failed. Contact your Authorized Service Center.
IlIII Care and Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards. Air Filter Cleaning The air filter should be checked necessary. particles Trapped of frost on the cooling at least once a month in the filter can build to see if cleaning up and cause coils. = Push the vent handle to the Vent Closed position(where applicable). • Open the front panel.
Before calling forservice, reviewthislist.It maysaveyoutimeandexpense. Thislistincludes common occurrences thatarenot theresultofdefective workmanship or materials inthisappliance. OCCURRENCE SOLUTION Air conditioner will not operate. Wall plug disconnected. Plug Current House fuse blown Control Air from unit does not feel cold enough. Device Tripped. Press the or circuit breaker is OFF. Turn Control Room temperature 60°F Push plug firmly below into wall outlet. RESET button. tripped.
Your appliance is covered by a full one-year warranty and a limited 2-5 year warranty(sealed system). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.