User's Manual

7
OPERATING INSTRUCTIONS
IMPORTANT
Clean the lint fi lter after every load. CLEAN FILTER
will be displayed at the end of the cycle to remind you
to remove lint from the fi lter.
2 Check that the lint fi lter is clean and in place.
Í
NOTE
Over-drying can cause wrinkles, shrinkage, lint,
harshness and a build up of static electricity.
Í
NOTE
If a setting is not available for the cycle selected, the
indicator will not light.
3 Load the dryer and close the door.
Load items loosely. The average wet load will •
fi ll the drum 1/3 to 1/2 full. Items need room to
tumble freely for even drying and less wrinkling.
If desired, place a dryer fabric softener sheet on •
top of the load at the beginning of the cycle.
To save energy and time and avoid uneven drying •
and wrinkling, do not overload the dryer.
When drying large items, dry only two or three •
items at a time. Fill out the load with small and
medium sized items.
For delicate or very small loads, add two or three •
similar items to improve tumbling action.
4 Select the appropriate cycle and settings for
each load.
Adjustments made to a cycle will be remembered and •
recalled each time that cycle is selected in the future.
Turn the cycle selector knob in either direction to •
select the cycle desired. The indicator for that cycle
will be illuminated.
The estimated drying time for Auto Dry cycles or •
the actual drying time for Timed Dry cycles will be
displayed.
A suitable drying temperature, dryness level and •
options will automatically be indicated for the cycle se-
lected. See the “Dryer Settings Chart” for more details.
To change the drying temperature and dryness •
level, press the Temp or Dry Level buttons to
scroll to the desired settings.
To select or delete an option, press the button for •
that option. The indicator will be illuminated when
the option has been selected. The indicator will no
longer be lighted when the option has been deleted.
Operating Your Dryer, continued
5 Start the cycle.
Close the door and press • Start to begin the cycle.
The dryer will not operate with the door open. To
interrupt the cycle, press Pause; press Start to
resume the cycle. Press cancel to stop the cycle.
If changes to the cycle, temperature, dryness level •
or options are attempted after the cycle starts, the
lights will blink and a signal will beep.
To change the cycle once the cycle has begun, •
press cancel and select a new cycle. To change
the temperature, dryness level or options once the
cycle has begun, press Pause and make the new
selections.
To add or remove items when the dryer is running, •
open the door. The dryer will stop when the door
is opened. Allow the drum to come to a complete
stop before reaching inside.
Close the door and press • Start to resume the cycle.
A signal will sound at the end of the cycle if the •
chime option has been selected.
6 When the cycle ends, remove items immedi-
ately and hang or fold.
To return to factory
settings, press these
two buttons at the
same time and
hold until the signal
sounds.