Installation guide

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire room air conditioner

INSTALLATIONINSTRUCTIONS

_J_,_;i_ %_ _ _ _ _i_ _D _

Gathertherequiredtoolsand partsbeforeste_ng installation.

Readand Iollowtheinstructionsprovidedwithanytools listed

here.

Tools Needed

• Flat-bladeandPhillips • Tapemeasure

screwdrivers • Drmlland_a="orsmaller bit

• Level

Through-the,Wall Installation:

In addition to the tools listed above, the Iollowing tools are

needed Ior through-the-wall installation.

• ,Saw • 1" (2,5 cm)orthicker

lumber

• Wood preservative

• Caulk • #10 x 1"wood screws(7)

Parts Supplied (on some models)

Checkthatall partsare includedinpartspackage.

C O E F

A. Foam window sash seal

B. t&qndowlock brecke(s (2)

C. #10x (_'pan-head Ph#/tps

screws (6)

O. 110 x _" pan-head

Philflps screws (3)

E. #lO x _/4"round-head screws (6)

F, llOx tla" pan-head Phil#ps

SCreWS(3)

G. Topchannel

H. SMe curtains (2)

I.Foam seal

IMPORTANT:Observeall governingcodesand ordinances.

Checkthe locationwhereair condiUonerwill be installed.Proper

installationisyourresponsibility. Makesure you ha_eeverything

necessaryfor correctinstallation.

Thelocationshouldprovide:

• Groundedelec_'icaloutle(within 4 It(122 cm)ol wherethe

powercordexitsthe airconditioner.

NOTE:Do not usean extensioncord,

• Freemovementofair inroomtobe cooled.

• A largeenoughopeningforthe airconditionen

• Adequatewallsupportforweightof airconditioner.Air

conditionerweighsbetween99 and 95 Ibs(36to 44kg).

NOTE: Cabinetlouversmustnot be obstructed.Air mustbe able

passIreelythrough the cabinetlouvers,

A. Cabinet louvers

NOTE: Installation partsare suppliedfor double-hungwindows

upto 40" (101.6cm)wide.Aspecial WideWindowKitisavailable

Immyourdealeror servicecenter.See "Accessories."

P/N 66129901291 1

Summary of content (8 pages)

PAGE 1
INSTALLATIONINSTRUCTIONS _J_,_;i_ %_ _ _ _ _i_ _D _ Gatherthe requiredtools and parts beforeste_ng installation. Read and Iollowthe instructionsprovidedwith any tools listed here. IMPORTANT:Observe all governingcodes and ordinances. Check the locationwhere air condiUonerwill be installed.Proper installationis your responsibility. Make sure you ha_eeverything necessaryfor correct installation.
PAGE 2
I- --1 l 1 A. 27" (68.6cm) minimum B. 16114"(41.3 cm)minimum • Height: 16" (40,6 cm) plus twice thickness of wood used to build frame. • Depth: 21tz"(6,4 cm) minimum to 6"(15,2cm) maximum, C A. _6"(4o.ecm) C. Wood thickness B. 22sis" (57. 5 cm) D. 2 h" (6.4) minimum to 6 "(15.2cm) maximum.
PAGE 3
INSTALLATION INSTRUCTIONS 4. Removethe window lock bracketand screwfrom the air condil_onerand set aside,(onsome models) E]messlve Weight Hazard Uee two or more poople to move end Install air conditioner, Failure to do so can rneult In beck or othor Injury.
PAGE 4
NOTES: Bottom view • Handle the air conditionergently, • Be sure your air conditioner cabinet does notfall outof the opening during installation or removal. The place where the power cord exits the air conditioner should be no more than 4 ft(122 cm) from a grounded 3 prong outlet • Do not blockthe louverson the front panel, • Do not block the louvers on the out.side of the airconditioner, A B A. Curtain housing B.
PAGE 5
Install Cabin_ _to Wi_d_ Attach Side Curtains to Window Frame • Handlethe air conditionergently. • Be sure yourair conditionercabinetdoes not{all outof the openingduring installationor removal. • The place where the power cordexits the air conditioner shouldbe no more than 4 ft(122 cm)from a grounded 3 prongoutlet 1. Pull the left-handcurtainout untilitfits intothe window channel.Use a s/=z"drillbitto drilla starter holethrough the hole in the curtain housingand intothe lowerwindow sash.
PAGE 6
Co_ta Installation 1. Insert seal behind the top of the lower window sash and againstthe glass of the upperwindow. 2. Place one window-lock bracket on Lop of lower window and against upper window sash on each side of the window. 3. Use a 3/_. drill bitto drill a starter holes through the holes in each bracket into the window sash. 4. Attach both the window-lock brackets to the window sash with #10 x ¾" round-head screws to secure window in place. A A A, Window lock brackets B.
PAGE 7
• Use 1" (2.5 cm) or thickerlumberIor wood Irame. Insertcabinet into the Iremed wall opening.The top of the 2, cabinetshuuld extend zf4 (19.1 ram) into the room.If there is trim,the cabinet should extend _/4 (19.1 mm) past the trim. B A. Outside width 8. Outside height C. Depth A. 3/4(19.1mm)extending int_room B. Ttfm 4. Apply the wood preservaUve to the outsideexposedsurlace. 5. Insertthe Ireme In the wall opening.Square and levelIrame. 6. Attach Irame securelyto the wall.
PAGE 8
! Electrical Shock Hazard ! Connect green ground wire to ground screw, 5. Insertfronttabs of frontpanel intotop of cabinetand swing frontinto place, 6. Attach bottomIront of panelwith frontpanelscrews,Replace controlknobs{onsome models), Failure to do so can result In death or electrical shock. 3. Connectgreengroundwire to cabinetbasewith groundscrew, Position groundwire pointingstraightup, Putexcess ground wire between coiland air conditionercabinet, A. Green ground wire B. Ground screw 4.