FRIGIDAIRE _;!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i! _7i!_i_i_i_i_i_i_iiiiiiiii_i_i_ii_i_i_i_i_1i7_7_7_ _'_i_7i_71_7_7_i_71117_)_i! , _!i!{:i!i Normal Air( Sounds ,i;i;ii www,frigidaire.
This USE & CARE MANUAL instructed may occur. in this provides specific USE & CARE MANUAL. Common sense operating These and caution instructions instructions must be practiced for your are not meant when installing, model. to cover operating, Use the room every possible air conditioner condition and maintaining only as and situation that any appliance. The power supply cord with this air conditioner contains a current detection device designed to reduce the risk of fire.
CAUTION. I Avoid Injury o Provide units o occasional ventilation during use. Do not direct or damage to the unit or other airflow at fireplaces or other heat related property sources as this could cause flare ups or make run excessively. Do not climb Do not hang on or place objects on outdoor objects off the unit. part of the unit. Do not place containers with liquids on the unit.
Product Registration Record Your Hodel and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Packaging Remove all packaging from inside the carton, along with any inserts placed into the side louvers.
Air Conditioner I ON/OFF ELECTRONIC Features CONTROL Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the touch pad alone or with the remote.
Operating Instructions (continued) TO CHANGE TEMPERATURE SETTING, YOU WILL SEE: DO THIS; PRESSTO RAISE PRESSTO LOWER Note: Tap or hold either be automatically matically actual maintained room up (A) maintained anywhere temperature. TO ADJUST (v ) or down anywhere between between button until the desired @ temperature is seen on the display. 60 °F (16 °C) and 90 °F (32 °C) for cooling 55 °F (13 °C) and 80 °F (27 °C) for heating See "To Operate on Fan Only" section mode.
Operating Instructions (continued) TO OPERATE ON FAN ONLY: YOU WILL SEE: LIGHT ON DO THIS: PRESS MODE BUTTON CHOOSE FAN ONLY Note: Use this function (Remember to open only when cooling the vent during choose any fan speed you prefer. During this cannot be selected function, the display when is not desired, this function, (Except "Auto such as for room but keep it closed air circulation during cooling or to exhaust for maximum stale air on some models. cooling efficiency.
Operating Instructions (continued) CHECK FILTER FEATURE: YOU WILL SEE: LIGHT OFF LIGHT ON DO THIS: o < (> PRESS CHECK FILTER BUTTON Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Check Filter" button and the light will go off.
Operating Instructions (continued) REMOTE SENSING FEATURE (on some models): LIGHT pulsi ( On & Off intermittently ). DO THIS: I SENSING PRESS REMOTE START BUTTON NOTE: Unit display Note: This feature To activate the" A_lV" can be activated the remote buttons from sensing feature, to set the desired itself ).
Operating Instructions (continued) FAULT CODES; If the display reads "HS", a sensor has failed. Contact your Authorized Frigidaire Service Center. If the display ADDITIONAL Now that you have mastered o The "Cool" • There this time.
Care and Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards, I Air Filter Cleaning The air filter should necessary. Trapped be checked at least once a month to see if cleaning is particles in the filter can build up and cause an accumulation of frost on the cooling • Push the Open the Grasp the Wash the thoroughly. thoroughly Or instead Cabinet coils.
Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. OCCURRENCE SOLUTION Air conditioner will not operate. Wall plug disconnected. Push plug firmly into wall outlet. Plug Current Device Tripped. Press the RESET button. House fuse blown or circuit breaker tripped, Replace fuse with time delay type or reset circuit breaker, Control is OFF.
Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
