Manual

Operating

(continued)

FAULT CODES;

Instructions

If the display reads "HS", a sensor has

failed. Contact your Authorized Frigidaire

Service Center.

If the display reads "AS", a sensor has

failed. Contact your Authorized Frigidaire

Service Center.

If the display reads "ES", a sensor has

failed. Contact your Authorized Frigidaire

Service Center.

ADDITIONAL THINGS YOU SHOULD KNOW

Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.

o The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly.

This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue

to run during this time.

• There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY/HEAT. This is to cover the possibility of

having to roll through to select another mode.

• The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees (in cool mode), 55F

and 80F degrees (in heat mode).

• The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to the other and

back, press and hold the "TEMP/TIMER" Up ( A ) and Down ( v ) buttons together for 3 seconds.

• After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.

Fresh Air Vent Control (on some models)

The Fresh Air Vent allows the air conditioner to:

1. Redrculate inside air - Vent Closed (see Fig. 1)

2. Draw fresh air into the room - Fresh Air (see Fig. 2)

3. Exchange air from the room - Vent Open (see Fig. 3)

Fig. 1 (VENT CLOSED) Fig. 2 (FRESH AIR) Fig. 3 (VENT OPEN)

The louvers will allow you to direct the air flow Up or Down and Left or Right

throughout the room as needed. Rotate the Auger Wheel until the desired

direction is obtained.

AUGER WHEEL