Installation guide

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire room air conditioner

|nsta||ation |nstruc ions

READ BEFORE iNSTALLiNG UNiT

OPP5K Window Mounting

Your air conditioner is designed to install in standard

double hung windows with opening widths of 23 to 36

inches (584 mm to 914 mm) (FIG. 1)

Lower sash must open sufficiently to allow a clear vertical

opening of 13 inches (330mm). Side louvers and the

rear of the AC must have clear air space to allow

enough airflow through the condenser, for heat removal.

The rear of the unit must be outdoors, not inside a

building or garage.

Fig. 1

__ EXTERIOR

min

Imm

NOTE: SAVE CARTON and these INSTALLATION

INSTRUCTIONS for future reference. The carton is the

best way to store unit during winter, or when not in use.

Some assembly is required. Please read these instructions

carefully.

Mounting Hardware

3/4" screws

lock frame

sash lock

Qty.

TOOLS NEEDED:

• PhillipsScrewDriver

. Drill(Ifpilotholesareneeded)

NOTE: DO NOT USE ANY SCREWS OTHER THAN

THOSE SPECIFIED HERE

When handling unit, be careful to avoid cuts

from sharp metal edges and aluminum fins on

front and rear coils.

Before installing unit, the top rail must be

assembled on the unit.

Top Rail Hardware Qty.

_ 3/8" Screw 4

Top Rail 1

Top

TOOL NEEDED:

• Phillips Screwdriver

D°

Remove the air

conditioner from the

carton and place on a

fiat surface.

Remove top rail from

the bottom of the

packaging material as

shown in Fig. A

Align the hole in the

top rail with those in

the top of the unit as

shown in Fig. B

Secure the top rail to

the unit with the 3/8"

Screws as shown in

Fig. C

ging Fig. A

NOTE: FOR SAFETY REASONS, ALL

FOUR (4) SCREWS MUST BE SECURELY

FASTENED.

P/N 2020211A0415

Summary of content (3 pages)

PAGE 1
|nsta||ation |nstruc ions READ BEFORE iNSTALLiNG UNiT OPP5K Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 1) When handling unit, be careful to avoid cuts from sharp metal edges and aluminum fins on front and rear coils. Lower sash must open sufficiently to allow a clear vertical opening of 13 inches (330mm).
PAGE 2
How to Install NOTE: Top Rail offset to provide This is necessary and drainage. If any reason, this and Sliding Panels at each side are the proper pitch to the rear of (5/16"). for proper condensed water utilization you are not using the Side Panels for pitch to the rear must be maintained! Place unit on floor, a bench or a table. There is a Left and Right Window Filler Panel - be sure to use the proper panel for each side.
PAGE 3
Place the extensions frame lock between the frame and the window sill as shown Cut foam seal and insert between the upper and (FIG.13). (Fig. 8). Drive 3/4" (19 ram) locking screws through the frame lock and into the sill (FIG. 9). NOTE: To prevent window sill from splitting, drill 1/8" (3 ram) driving screws. pilot holes in the space lower sashes before IfAC is Blocked Window by Storm Add wood as shown in FIG. 14, or remove window before air conditioner is installed. storm FiG.