Installation guide

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire room air conditioner

m m

READ BEFORE INSTALLING UNIT

OPP5K Window Mounting

Your ah"conditioner is desigl_ed to install in skmdard

double lluug windows with opening widths ol 25 to 36

inches (635 mm to 914 ram) (FIG. l)

Lower sash must open suificiently to allow a clear vertical

opeuing of 14-1/2 inches (368 rnm). Side louvers and the

rear of the AC must have clear air space to allow

enough airflow through the condensel; for heat removal.

The rear of' the unit must be outdoors, not inside a

building or garage°

When handling unit, be careful to avoid cuts

from sharp metal edges and aluminum fins on

front and rear coils.

Beibre installing unit, the top rail must be

assembled on the uuR.

_l[bp Rail Hardware Qty.

3/8" Screw 4

Top Rai_ 1

NOTE: SAVE CARTON and these INSTALLATION

iNSTRUCTiONS for furore reiereJlce. The carton is the

best way to store unit during winter, or when not in use.

Some assemNy is required. Please read these instructions

Mounting Hardware

3/4 *screws

k)ck frame

sash lock

TOOLS NEEDED:

* Drill (if pilot holes are needed)

Qty.

TOOL NEEDED:

* Phillips Screwdriver

A. Remove the air

conditiouer flTom tile

carton and place on a

fiat surface.

B. Remove top rail from

tile bottom of tile

packaging material as

shown in Fig. A

C. Align the hole hi the

tile top of tile unit as

shown in Fig. B

D. Secure tile top rail to

rite unit with the 3/8"

Screws as shown in

Fig. C

Fig. A

Top Rail

NOTE: FOR SAFETY REASONS, ALL

FOUR (4) SCREWS MUST BE SECURELY

FASTENED.

Summary of content (3 pages)

PAGE 1
m m READ BEFORE INSTALLING OPP5K Window Mounting Your ah"conditioner is desigl_ed to install in skmdard double lluug windows with opening widths ol 25 to 36 inches (635 mm to 914 ram) (FIG. l) Lower sash must open suificiently to allow a clear vertical opeuing of 14-1/2 inches (368 rnm). Side louvers and the rear of the AC must have clear air space to allow enough airflow through the condensel; for heat removal.
PAGE 2
How to Install NOTE: Top Rail and Sliding Panels a_teach side are offset to provide the proper pi_.eh to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch _.othe rear must be main_.
PAGE 3
Place the frame lock between the fi°ame extensions and the window sill as shown Cut _bam seal and insert in the space between the upper and lower sashes (FIG. 13). (Fig. 8). Drive 3/4" (19 nmO k)cking screws through the frame k_ck and into the sit1 (FIG. 9). NOTE: '[b prevent wh_dow sill from splitting, drill 1/8" (3 mm) pilot holes before driving screws. FIG. 8 IfAC is Blocked by Storm Add wood as shown in FIG. 14, or remove storm window before air conditioner is installed.