Use and Care Manual

26
Cleaning drip bowls
Wash in hot, soapy water. Rinse and dry while
still warm. Hard to remove, burned-on soil can
be removed by soaking the drip bowls for about
20 minutes in a lightly diluted liquid cleanser or a
solution of ammonia and water (1/2 cup ammonia
to 1 gallon of water). A nylon scrubber may be used
after soaking. Do not use abrasive cleaners or steel
wool, they will scratch the surface. Always rinse
with clean water and polish dry with a soft cloth.
To replace drip bowls and surface elements:
1. Slide the terminal end on the element through
the opening in the drip bowl.
2. Align the element support to rest on the
rim inside the drip bowl. If your drip bowl is
equipped with a hold-down clip, align the
element support opposite the terminal end with
the slot in the hold-down clip, and snap into
place.
3. After the element is positioned in the drip bowl,
line up the terminal end with the terminal plug
as shown.
4. Hold the surface element and drip bowl
together as level as possible and firmly push
the terminal end into the terminal plug. Make
sure element terminal is seated properly into
terminal plug. Make sure the surface element is
level to reduce the hazard of cookware sliding
o the element.
CARE AND CLEANING
Replacing the Oven Light
CAUTION
Be sure the oven is unplugged and all parts are
cool before replacing the oven light.
Figure 20: Oven light
Replacing the oven interior light bulb:
The interior oven light is located at the rear of the
oven cavity and covered with a glass shield. The
glass shield must be in place whenever the oven is
in use (Figure 23). Only use lamps with the same
specifications.
1. Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
2. Turn electrical power o at the main source or
unplug the appliance.
3. Turn the lamp glass cover counterclockwise to
remove it.
4. Clean the glass cover.
5. Replace the lamp with a suitable 300°C heat-
resistant lamp.
NOTE
Do not allow your fingers to touch the new bulb
when replacing. This will shorten the life of the
bulb. Use a paper towel or cotton glove while
handling the new bulb when installing.
6. Replace glass oven lamp glass cover.
7. Turn power back on again at the main source
(or plug the appliance back in).