Manual

Note: Prior to assembly remove protective film from stainless steel parts
Cart Assembly
Screw Holes
3crew Holes Fig. 1
.
Set 3 sided pedestal upside down. Set the base
on the top of the cart assembly aligning the four
wheel channel holes and 2 screw holes. Then set
the 2 wheel channels on the base and attach them
using the (4) bolts provided, fiom inside the cart
upwards through wheel channels. (See Fig. 1 & 2)
Attaching Grill Head to Cart
1. With the grill on its back, (be sure to hold the
hood shut when doing this) loosen all 4 bolts
on the bottom side of the grill. (See Fig. 3)
.
Note:
[]ave someone help you pick up the grill and set it
on the top of the cart, with the rear of the grill
above the opening. Make sure the 4 bolt heads
fall through the large opening of the key hole slots
in the top of the cart. Slide the grill head
backward so the bolts are resting in the small
opening of the key hole slots. Tighten the bolts
securely-be sure not to over tighten and strip the
bolts. Next insert 2 hex head screws into grill
bottom through cart & 2 hex head screws into the
cart base. (See Fig. 4)
This is a very heavy step that requires
two individuals to complete.
Fig. 2
Fig. 3
Fig. 4