User manual

PROBLEM POSSIBLE SOLUTION
You cannot activate the appliance. Make sure that the mains plug is connected
to the mains socket.
Check fuse in fuse box (domestic installa-
tion).
The programme does not start. Press Start/Pause.
Make sure that the appliance door is closed.
The appliance door does not close. Make sure that the installation of the filter
is correct.
Make sure that the laundry does not catch
between the appliance door and the rubber
seal.
The appliance stops during operation. Make sure that the water container is emp-
ty. Press Start/Pause to start the pro-
gramme again.
The cycle time is too long or unsatisfactory
drying result.
1)
Make sure that the weight of the laundry is
applicable to the duration of the pro-
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Ensure that the room temperature is higher
than +5°C and lower than +35°C. Optimal
room temperature is 19°C to 24°C.
Set the Time Drying or the Extra Dry pro-
gramme.
2)
The display shows Err. If you want to set a new programme, deac-
tivate and activate the appliance.
Make sure that the options are applicable to
the programme.
The display shows (e.g. E51). Deactivate and activate the appliance. Start
a new programme. If the problem occurs
again, contact the Service.
1)
After maximum 5 hours, the programme ends automatically.
2)
It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
19
TROUBLESHOOTING