User manual

If the appliance does not start or it stops
during operation, before you contact the
Service, check if you can solve the problem
by yourself with the help of the information
in the table.
With some problems different indicators
flash intermittently and/or continuously to
show an alarm code.
PROBLEM AND ALARM CODE POSSIBLE SOLUTION
You cannot activate the appli-
ance.
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no a damage fuse in the
fuse box.
The programme does not start.
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance has started the procedure to re‐
charge the resin inside the water softener. The du‐
ration of the procedure is approximately 5 minutes.
The appliance does not fill with
water.
• The indicator flashes 1 time
intermittently.
• The indicator Start flashes
continuously.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog‐
ged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the
water.
• The indicator flashes 2
times intermittently.
• The indicator Start flashes
continuously.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
The anti-flood device is on.
• The indicator flashes 3
times intermittently.
• The indicator Start flashes
continuously.
• Close the water tap and contact the Service.
Once you have checked the appliance,
press Start . If the problem occurs again,
contact the Service.
For alarm codes not described in the table,
contact the Service.
16
TROUBLESHOOTING