Installation guide

improper connection of aluminum
house wiring to copper Jeads can result in a short
circuit or fire. Use only connectors designed for
joining copper to aluminum, and fo!low the
manufacturer's recommended procedure closely.
• If the existing cutout width is greater than
30 1/!6" (76,4 cm), reduce the 3A" (1.9 cm)
dimension.
NOTE TO ELECTRICIAN: The armored cable leads
supplied with this appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than the temperature rating of household wiring.
The current carrying capacity of the conductor is
governed by the temperature rating of tile insulation
around the wire, rather than the wire gauge alone.
Range JnstaINation
The eJectricat power to the range
must be shut off whiJe Hne connections are being
made. Failure to do so could result in serious injury
or death.
(1.9 cm)
I
(1.9cm)
/
/
311/£_
(81cm)
Formed or tile countertop
trimmed ¾" (1.9 cm) back at
front corners of countertop
opening.
Figure 4
Countertop Preparation
The cooktop sides of the range fit over the cutout edge
of your (ountertop.
If you have a square finish (fiat} countertop, no
countertop preparation is required. Cooktop sides lay
directly on edge of countertop.
• Formed front-edged countertops must have molded
edge shaved flat 3/4" (1.9 cm) from each front corner
of opening (Figure 4).
• THe countertops may need trim cut back 3/4"(! .9
cm) from each front corner and/or rounded edge
flattened (Figure 4).
• For existing cutout width of 29" (73.7 cm) (Figure 5):
(S.2 cm)
Figure 5
You must also dear
2 3/16" (5.56 cm) of
material from front
of countertop.
Formed or the countertop
trimmed 11/4" (3.2 cm) back at
front corners of countertop
opening.