Owners manual
6
and fix the top hinge on the door,to make the door level,see chart 8.
Step 14:Check the sealing of the door,then refit the parts �ǃ�.
Chart 8
Placement of Wine Cooler
The wine cooler should be placed in dry and ventilated room. The location of
the wine cooler should not be irradiated by direct sunshine. The wine cooler
should be far away from heating sources, such as: cooking stove or heating
radiator. If the wine cooler has to be placed near heating source, please adopt
proper heating insulation board for insulation or keep the wine cooler at least
the following minimum distances away from the heating sources:
For electric stove: 3 .
For oil or coal stove: 30 .
Replacement of Door Hinge
The door hinges of this wine cooler can be interchanged between the left and
right sides.
Installation of Handle
1. Set the handle on the fixation shaft.
- 10 -
Chart 2
Step 7:Remove the bolt on the bottom of the door by screwdriver�(see chart
3)
Step 8:Remove the screw� and the block �,then set them on the left side.(see
chart 3)
ľ
ļ
Ľ
Chart 3
Step 9:Change the hinge axis� from the right hole to left hole(see chart 4)
Ŀ
Chart 4
Step 10:Use knife to remove the parts�,see chart 5.
- 8 -
Boquilla
Soporte
de
detención
Instale el enfriador de bebidas en la parte
más fría de una habitación ventilada y
seca, lejos de la exposición directa de
la luz solar y lejos de los conductos de
calefacción o registros. No coloque el
enfriador de bebidas y vinos cerca de
electrodomésticos que produzcan calor
como una cocina, horno o lavavajillas.
Nivele el enfriador de bebidas de manera que la puerta se
cierre bien.
No llene en exceso el enfriador de bebidas o bloquee
las ventilaciones de aire frío. Si lo hace, provocará que
el enfriador de bebidas funcione más y utilice más
energía. Los estantes no deben estar cubiertos con
láminas de aluminio, papel de cera o toalla de papel. Los
revestimientos intereren con la circulación de aire frío, lo
que hace que el enfriador de bebidas y vinos sea menos
eciente.
Limpie en seco los envases antes de colocarlos en el
enfriador de bebidas. Esto disminuye la acumulación de
humedad dentro de la unidad.
Organice el enfriador de bebidas para reducir las aperturas
de la puerta. Retire tantos artículos como sea necesario
una sola vez y cierre la puerta lo antes posible.
INsTALACIÓN
Para un mejor funcionamiento, deje pasar 4 horas para que el enfriador de bebidas se enfríe completamente. El enfriador de bebidas
funcionará continuamente durante las primeras horas.
Indication of Temperature in Lower Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature decrease 1°C.
Indication of Temperature in Upper Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature decrease 1°C.
: Temperature display.
Light: Lighting button for LED lamp; it controls the on/off of lamp.
Power: On/off button used to turn on/off all load.
Press Light and Power together for 2 seconds and you can convert between
fahrenheit temperature and Celsius temperature.
Notice!
z The default temperature is 10/10°C, and the temperature after power
failure will be the temperature set before the power failure.
z To elongate the service life of compressor, please wait for at least 5
minutes before the wine cooler is restarted after power failure.
z Failure display
z If there is failure on the sensor, the screen may display failure code, such
as: E and F. When the screen displays the above-mentioned errors, please
do not disassemble it for check by yourself. You should contact local
after-sales service personnel for repair.
z If the temperature in the cooler is too low, it will display “L”.
When the temperature in the cooler is too high, the screen will display “H”
and will flash; under this state, the buzzer will buzz until 30 seconds; one
minute later, the buzzer will continue to give alarm in the next 30 seconds; after
the alarm is given for three times, it will not give alarm any more. You can
press any key to cancel sound alarm.
z When you put a lot of wines together in the cooler, the temperature in the
cooler may rise temporarily.
- 10 -
este botón ENCIENDE y APAGA la luz.
este botón ENCIENDE y APAGA la alimentación.
Pulse los botones de y al mismo tiempo para
cambiar entre temperaturas Fahrenheit y Celsius.
Indication of Temperature in Lower Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature decrease 1°C.
Indication of Temperature in Upper Chamber
: Press this button once and the temperature increase 1°C.
: Press this button once and the temperature decrease 1°C.
: Temperature display.
Light: Lighting button for LED lamp; it controls the on/off of lamp.
Power: On/off button used to turn on/off all load.
Press Light and Power together for 2 seconds and you can convert between
fahrenheit temperature and Celsius temperature.
Notice!
z The default temperature is 10/10°C, and the temperature after power
failure will be the temperature set before the power failure.
z To elongate the service life of compressor, please wait for at least 5
minutes before the wine cooler is restarted after power failure.
z Failure display
z If there is failure on the sensor, the screen may display failure code, such
as: E and F. When the screen displays the above-mentioned errors, please
do not disassemble it for check by yourself. You should contact local
after-sales service personnel for repair.
z If the temperature in the cooler is too low, it will display “L”.
When the temperature in the cooler is too high, the screen will display “H”
and will flash; under this state, the buzzer will buzz until 30 seconds; one
minute later, the buzzer will continue to give alarm in the next 30 seconds; after
the alarm is given for three times, it will not give alarm any more. You can
press any key to cancel sound alarm.
z When you put a lot of wines together in the cooler, the temperature in the
cooler may rise temporarily.
- 10 -
Pulse este botón una vez para aumentar la temperatura en 1° F o C.
Pulse este botón una vez para disminuir la temperatura en 1° F o C.
El refrigerador para bebidas puede ser ajustado usando los botones de control de temperatura (echas hacia arriba y hacia
abajo).
El rango de temperatura MÍN. y MÁX. es de 41° a 64°F (5° a 18° C).
CONTROLEs DE LA TEMPERATURA