Wiring Diagram
SERVICE DATA SHEET
P/N: A03589801 Rev.A
Artwork: A03589801 Rev.001
This information is intended for use by persons having electrical and
mechanical training and a level of knowledge of these subjects generally
considered acceptable in the appliance repair trade. Electrolux Home
Products North America cannot be responsible, nor assume any liability,
for injury or damage of any kind arising from the use of this Service
Data Sheet.
BK............Black
BU............Blue
PK............Pink
R..............Red
Viol..........Violet
W.............White
Y..............Yellow
R-Y.........Red/Yellow
R-BK......Red/Black
COLOR CODE
OPERATION
WARNING
DISPLAY CODES (LED)
WIRING DIAGRAM
CYCLE SELECTION OPTIONS
To start ----------------- Close door fully to latch. Press START/CANCEL pad.
To delay start --------- Close door fully to latch. Press DELAY START pad to select desired
delay time.
To select a new cycle
or option ------------- Press desired cycle and/or option pad.
The indicator lights will change. Press START/CANCEL within
15 seconds to begin cycle.
To cancel
a cycle ---------------- Press START/CANCEL. Dishwasher will drain for 90 seconds, then
shut off.
Disconnect electrical power at
the fuse box or circuit breaker
box before servicing under
this product. Electrical power
may be present on some parts
under this product, even if
not in use.
Failure to follow this warning
could result in serious injury or
death.
WASHING ----------- Washing portion of cycle.
SANITIZED ----------The SANITIZATION criteria has been met. Indicator
light switch off when door is closed.
DRYING ------------- Drying portion of cycle.
CLEAN---------------- Shows Completion of cycle. Indicator light will
switch off when door is opened.
OPTION LED’S
fl ashing-------------- All LED’S fl ashing indicates power failure has
occurred. Press START/CANCEL pad and reselect
desired options and cycle.
STATUS LED’S
fl ashing------------- The STATUS LED’s that are lit when the door is opened
will fl ash. Close Door.
Interval Number
Description
1
2
6
4
3
5
7
8
Fill/Det. Dispenser
Fill
Wash/Heat
Wash/Heat/Det. Disp.
Wash/Heater On
Pause/Heat
Drain
Drain/Dry/Heater On
End State
Interval Duration Sec.
60
27
60
0.4
75
60
90
90
Water Valve
Circulation Motor
Drain Motor
Heater
Dispenser
Washing LED
Sanitize LED
Drying LED
Clean LED
0
1
0
1
1
1
1
1
1
1
1
1
x
1
0
0
0
1
0
1
0
0
0
0
0 1
0
0
0
0
0
0
1
0 0
0
0
0
1
1
0
0
0 0
0
0
1
0 0
0
0 0
1
0
0
0
0
0
1 0 0
0
0
0
0
1
0
0
0 0
1
0
0
0
0
1
X - denotes selectable option
Clean LED stays on until door is opened or cycle is started
Notes
0 0 0 0 0
WATER/SERVICE TEST
The water/service test, (WST)
is a special function initiated
from the power failure mode
or idle mode.
While in power failure mode
- simultaneously press the HEAT
DRY and START/CANCEL pads for
one half second.
The dishwasher will then step
through the test cycle per the
chart. Pushing the START/CANCEL
pad will advance the dishwasher
to the next step.
While in idle mode -
simultaneously press the HI-TEMP
WASH and START/CANCEL pads
for 3 seconds.
To Exit the WST - Open and
Close the door.
LEDs