Wiring Diagram
SERVICE DATA SHEET
P/N: A13707601RevA
Artwork: A06401801Rev001
This information is intended for use by persons having electrical and
mechanical training and a level of knowledge of these subjects generally
considered acceptable in the appliance repair trade. Electrolux Home
Products North America cannot be responsible, nor assume any liability,
for injury or damage of any kind arising from the use of this Service
Data Sheet.
BK............Black
BU............Blue
PK............Pink
R..............Red
Vio...........Violet
W.............White
Y..............Yellow
R-Y.........Red/Yellow
COLOR CODE
OPERATION
WARNING
DISPLAY CODES (LED)
WIRING DIAGRAM
CYCLE SELECTION OPTIONS
To start ----------------- Close door fully to latch. Press START/CANCEL pad.
To delay start --------- Close door fully to latch. Press DELAY START pad to select desired
delay time.
To select a new cycle
or option ------------- Press desired cycle and/or option pad.
The indicator lights will change. Press START/CANCEL within
15 seconds to begin cycle.
To cancel
a cycle ---------------- Hold START/CANCEL pad for 3 seconds, the dishwasher will drain for
90 seconds, then shut off.
Disconnect electrical power at
the fuse box or circuit breaker
box before servicing under
this product. Electrical power
may be present on some parts
under this product, even if
not in use.
Failure to follow this warning
could result in serious injury or
death.
Interval Number
Description
1
2
6
4
3
5
7
8
Fill/Det. Dispenser
Fill
Wash/Heat
Wash/Heat/Det. Disp.
Wash/Heat
Pause/Heat
Drain
Drain/Dry/Heat
End State
Interval Duration Sec.
60
27
60
0.4
75
60
90
90
Water Valve
Circulation Motor
Drain Motor
Heater
Dispenser
Clean LED
0
1
0
1
1
1
1
1
1
1
1
1
1
0
1
0
0
0
0
0
0
0 1
0
0
0
0
0
0
0
0 0
0
0
0
0 0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0 0
1
0
1
0
Clean LED stays on until door is opened or cycle is started
Notes
0 0 0 0 0 1
WATER/SERVICE TEST
The water/service test, (WST)
is a special function initiated
from the power failure mode.
While in power failure mode -
simultaneously press the OPTIONS
and START/CANCEL pads for one
second.
The dishwasher will then step
through the test cycle per the
chart. Pushing the START/CANCEL
pad will advance the dishwasher
to the next step.
Pre-Wash 1
Minutes
Normal (HT)
Water Valve
Heavy Wash
5
10 15 20
25 30 35 40 45
50 55 60
65 70
75
80 85
90 95
100
105
110
115
120
125 5
10
15
20
5
10
15 20 25 30
35 40 45
Pre-Wash 2
Pre-Wash 3
Main Wash
Rinse 1
Rinse 2
Rinse 3 Final Rinse
Dry
Circulation Motor
Drain Motor
Heater
Dispenser
Water Valve
Circulation Motor
Drain Motor
Heater
Dispenser
Pre-Wash 1
Pre-Wash 2
Pre-Wash 3
Main Wash
Rinse 1 Final Rinse Dry
Pre-Wash 4
Minutes
Water Valve
*Rinse Only
Circulation Motor
Drain Motor
Heater
Dispenser
Pre-Wash 1
Pre-Wash 2
50 55 60 65 70 75 80 85 90
Normal
Minutes
Water Valve
Circulation Motor
Drain Motor
Heater
Dispenser
Pre-Wash 1
Main Wash
Rinse 1
Dry
*Energy Saver
Minutes
5
10 15
20
25 30 35 40 45
50 55
60
65 70
Pre-Wash 1
Main Wash
Final Rinse
Water Valve
Circulation Motor
Drain Motor
Heater
Dispenser
75 80
Rinse 1
Dry
Vent
Vent
Vent
Final Rinse
Vent
Vent
K4 03-05-14 (2014 ESTAR)
Note: The Main Wash and Final Rinse
may be lengthened when needed to reach
optimal wash temperatures.
130 135
* Some Models
SANITIZED ----------The SANITIZATION criteria has been met. Indicator
light switch off after 15 seconds of door open.
CLEAN---------------- Shows Completion of cycle. Indicator light will
switch off after 15 seconds of door open.
ALL LED’s
illuminated solid-----All LED’s illuminated solid indicates power failure has occured.
Press START/CANCEL pad and re-select desired options and
cycles.
START LED
fl ashing---------------The START LED will fl ash when the door is opened. Close the
door and press START/CANCEL to resume cycle.
STATUS LED’S
fl ashing---------------An error has occured.
Sanitize LED (if available)