Installation Manual

7
OPERATING INSTRUCTIONS
The Anti-Jam Swivell Impellers make a clicking sound as they swing into place. This indicates normal operation.
A. Remove sink stopper. Turn on a medium flow of cold
water.
B. Turn switch to ON position; your motor is turning at full
speed and ready to use.
C. Scrape in food waste. Down the drain go table scraps,
peelings, rinds, seeds, pits, small bones and coffee
grounds. to speed up food waste disposal, cut or break
up large bones, rinds and cobs. Large bones and fibrous
husks require considerable grinding time and are more
easily thrown away with other trash. Do not be alarmed
TIPS FOR SUCCESSFUL OPERATION
A. Be sure disposer is empty before using your dishwasher
so it may drain properly.
B. You may want to leave the stopper in the drain when not
in use to prevent utensils and foreign objects from falling
into the disposer.
C. Your disposer is ruggedly built to give you many years of
trouble free service. It will handle all normal food
wastes, but it will NOT grind or dispose of such items as
plastic, tin cans, bottle caps, glass, china, leather, cloth,
rubber, string, clam and oyster shells, aluminum foil or
feathers.
BATCH FEED OPERATING INSTRUCTIONS
A. Remove sink stopper and turn on a medium flow of cold
water.
B. Scrape in food waste. Down the drain go table scraps,
vegetable peelings, cobs, rinds, pits, bones and coffee
grounds. (see A)
C. Insert stopper to start disposer. (see B) One of the two
small slots in stopper base must line up with switch
plunger inside the neck of the disposer. Push down
firmly to turn the disposer on. Lift stopper to shut the
disposer off.
D. Run disposer for 15 seconds after shredding stops. This
assures that all waste is thoroughly flushed through the
drain.
E. To fill sink, insert stopper and align the largest slot with
the switch plunger. (see C) Push down to seal sink
without starting the disposer. When medium sized slot
(see B) in stopper base is lined up with the switch
plunger, water, can drain, but tableware, etc., cannot be
accidentally dropped into disposer.
that the disposer slows down while grinding. The
disposer is actually increasing torque (grinding power)
and is operating under normal conditions.
D. Before turning disposer off, let water and disposer run
for approximately 15 seconds after shredding stops.
This assures that all waste is thoroughly flushed through
trap and drain.
E. It is not recommended to use hot water while running
disposer. Cold water will keep waste and fats solid so
disposer can flush away particles.
The Anti-Jam Swivel Impellers make a clicking sounds as they swing into place. This indicates normal
operation.
MEDIUM
SLOT
SMALL
SLOT
A
B
C
LARGE
SLOT