Installation Guide

2
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
F
E
D
A
Figure 2 – COUNTERTOP CUTOUT OPENING
CAUTION
To eliminate the risk of burns or
fire by reaching over heated surfaces, cabinet
storage space located above the cooktop should
be avoided. If cabinet storage is provided, risk can
be reduced by installing a range hood that projects
horizontally a minimum of 5" (12.7 cm) beyond the
bottom of the cabinets.
Overhead Cabinet Should Not Exceed a
Maximum Depth of 13" (33 cm)
30" (76.2 cm) Min. Clearance
Between the Top of the
Cooking Platform and the
Bottom of an Unprotected
Wood or Metal Cabinet
24" (61 cm) Min. when
Bottom of Wood or Metal
Cabinet is Protected by
Not Less Than 1/8" Flame
Retardant Millboard Covered
With Not Less Than No. 28
MGS Sheet Steel, 0.015" (0.4
mm) Stainless Steel, 0.024"
(0.6 mm) Aluminum or
0.020" (0.5 mm) Copper
2 1/2" (6.4 cm)
Min. From Edge
of Cutout to Front
Edge of Countertop
Approximate Location of
Junction Box
18"
(45.7 cm)
* Letters on this figure refer to chart on
front page except for G, H and J.
H Min. From Edge of
Cooktop to Nearest
Combustible Wall (Either
Side of Unit).
25" Min.
(63.5 cm Min.)
12"
(30.5 cm)
10"
( 25.4 cm)
Min.
J Min. Recommended
Distance Between Rear
Edge of Cutout and
Nearest Combustible
Surface Above
Countertop
Important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing the cooktop.
2. Remove all packing material before connecting the
electrical supply to the cooktop.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
Important Note to the Consumer
Keep these instructions with your owner's guide for future
reference.
For a drawer installation below the
cooktop, allow Dimension G of clearance
underneath the countertop. The drawer
must not interfere with the electrical
installation of the cooktop or contain
flammable materials.
MODEL G H J
30"
4"
(10.2 cm)
7½"
(19.1 cm)
2"
(5.1 cm)
36"
4"
(10.2 cm)
7½"
(19.1 cm)
2"
(5.1 cm)