Use and Care Guide

34
CARE AND CLEANING
Removing and Replacing the Oven Door:
To remove the oven door
1. Open oven door completely, horizontal with floor (See
F
igure 23).
2. Pull the door hinge locks on both left and right door
h
inges down from the oven frame completely towards
the oven door (See Figure 24). A tool such as a small
flat-blade screwdriver may be required.
3. F
irmly grasp both sides of oven door along the door
side
s. Do not use the oven door handle (See
Figure 25).
4. Clo
se the door to approximately 10 degrees from the
d
oor frame (See Figure 25).
5. Lift the oven door hinge arms over the roller pins
lo
cated on each side of the oven frame (See Figure 26).
To replace the oven door:
1. F
irmly grasp both sides of oven door along the door
side
s. Do not use the oven door handle (See
Figure 25).
2. Ho
lding the oven door at the same angle as the removal
p
osition, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (See
Figure 25 and Figure 26). The hook of the hinge arms
must be fully seated onto the roller pins.
3. F
ully open the oven door, horizontal with floor (See
F
igure 23).
4. Push the door hinge locks up towards and into the oven
fr
ame on both left and right oven door hinges to the
locked position (See Figure 24).
5. Clo
se the oven door.
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
Special door care instructions - Most oven doors contain
glass that can break. Do not hit the glass with pots, pans,
or any other object. Scratching, hitting, jarring, or
stressing the glass may weaken its structure, causing an
increased risk of breakage at a later time. Do not close
the oven door until all of the oven racks are fully in place.
CAUTION
IMPORTANT
Figure 23: Door hinge location
Figure 24: Door hinge locks
Figure 25: Holding door for removal
Figure 26: Replacement and location of hinge arm and
roller pin
Oven door
hinge
locations
L
O
C
K
about
10°
hinge
oven
door
roller
pin
hinge
arm