Owner Manual

12
DOOR REMOVAL/REVERSAL
(UNITS WITH TEMPERATURE CONTROL OUTSIDE)
1. Unplug your freezer.
2. Lay the unit down on its back.
3. Disconnect the small blue and white
connectors located in the channel in
the bottom of the door (see Figure
1A).
4. Remove the gray cable from
underneath the 2 harness retaining
clips (see Figure 1B).
5. Pull the gray cable and connectors
through the hinge hole located on the
bottom of the cabinet using a flat-
head screwdriver.
6. Route the gray cable and the connec-
tors out from under the wheel axle
and the wheel spacer (see Figure 2).
7. Slide the gray cable and connectors
out of the plastic channel located on
the bottom right side of the cabinet
(see Figure 3).
A
B
Figure 1
CAUTION
This procedure will require 2 people to
safely perform.
Figure 2
+
Figure 3