All about the Use & Care of your Gas Range TA B L E O F C O N T E N T S Important Safety Instructions ........................... 3-6 Setting Oven Controls .................................. 10-13 Before Setting Oven Controls .............................. 7 Care & Cleaning .......................................... 14-17 Before Setting Surface Controls .......................... 8 Before You Call ............................................ 18-19 Setting Surface Controls ..........................
PRODUCT RECORD AND REGISTRATION Contents Product Registration ...................................................... 2 Important Safety Instructions ............................ 3-6 Before Setting Oven Controls .................................. 7 Removing, replacing & arranging the oven racks ........... 7 Before Setting Surface Controls .............................. 8 Cookware material types ............................................ 8 Setting Surface Controls .........................................
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Do not attempt to install or operate your appliance until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a WARNING or CAUTION statement based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
IMPORTANT SAFETY INSTRUCTIONS WARNING NEVER use this appliance as a space heater to heat or warm the room. Doing so may result in carbon monoxide poisoning. NEVER cover any slots, holes or passages in the oven bottom or cover an entire rack with materials such as aluminum foil. Doing so blocks air flow through the oven and may cause carbon monoxide poisoning. Aluminum foil linings may trap heat, causing a fire hazard.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT INSTRUCTIONS FOR USING YOUR COOKTOP WARNING Use Proper Flame Size—Adjust flame size so it does not extend beyond the edge of the utensil. The use of undersized utensils will expose a portion of the burner flame to direct contact and may result in ignition of clothing. Proper relationship of utensil to flame will also improve efficiency. • Know which knob controls each surface burner.
IMPORTANT SAFETY INSTRUCTIONS Important Safety Notice Conversion to Liquefied Petroleum Gas The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances.
BEFORE SETTING OVEN CONTROLS Oven vent location Removing, replacing & arranging racks The oven vent is located at center rear of cooktop below the control panel (See Fig. 1). When the oven is on, warm air passes through this vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block the oven vent. To remove - pull the rack forward until it stops. Lift up front of rack and slide out. To replace - fit the rack onto the guides on the oven walls.
BEFORE SETTING SURFACE CONTROLS Using proper cookware Set proper burner flame size For best cooking results, cookware should have flat bottoms that rests level on the burner grate. Before using cookware, check for flatness by rotating a ruler across the bottom of the cookware (Fig. 1). The color of the flame is the key to proper burner adjustment. A good flame is clear, blue and hardly visible in a well-lighted room. Each cone of flame should be steady and sharp.
SETTING SURFACE CONTROLS Setting surface controls Always select cookware that is suitable for the amount and type of food being prepared. Set a flame size appropriate to the pan. Adjust burner to a setting that does not allow flames to extend beyond the outer edge of the cooking utensil. When a surface control knob is turned to the LITE position, the selected surface burner will ignite automatically from a spark generated by the electric ignitor. Setting surface burners 1.
OVEN CONTROL FUNCTIONS READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various pad features and functions of the oven as described below. Feature indicator lights— These indicator lights show if bake or broil is active. Bake pad—Use to select the bake feature. Up and down arrow pads— Use with the feature or function pads to set oven temperature or adjusting the clock and minute timer. Broil pad— Use to select the variable broil feature.
SETTING OVEN CONTROLS Setting the minute timer Setting bake 1. Press timer on-off. The oven can be programmed to bake at any temperature from 170°F to 550°F (77°C to 287°C). The factory preset bake temperature is 350°F (177°C). 2. Press the to increase the time in one minute increments. Press and hold the to increase the time in 10 minute increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
SETTING OVEN CONTROLS Setting broil Use the broil feature to cook meats that require direct exposure to flame heat for optimum browning. Use the broiler drawer and rack along with the broil pan and insert when broiling. The broiler drawer offers 3 different broil rack positions. 3 rear locating hole positions tilt up front of rack to remove and adjust WARNING • DO NOT use oven or broiler drawer for storage. Items placed in oven or broiler drawer will catch fire.
SETTING OVEN CONTROLS Adjusting oven temperature Operating oven light (some models) Your appliance has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you think the oven is cooking too hot or too cool for your recipe times, you can adjust the control so the oven cooks hotter or cooler than the temperature displayed.
CARE & CLEANING Cleaning recommendation table Surface type • • • • Control knobs Painted body parts Painted decorative trim Aluminum, plastic or vinyl trim pieces Recommendation For general cleaning, use hot, soapy water and a cloth. For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. Do not use abrasive cleaners on any of these materials; they can scratch.
CARE & CLEANING Cleaning the cooktop and surface burners CAUTION • To avoid possible burns DO NOT attempt any of the cleaning instructions provided below before turning OFF all of the surface burners and allow them to cool. • Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized qualified Agency. Routinely clean the cooktop. Wipe with a clean, damp cloth and wipe dry to avoid scratches.
CARE & CLEANING Cleaning the cooktop and surface burners (cont’d) To clean the surface burner heads For proper gas flow it may be necessary to clean the burner ports. Before cleaning be sure the gas burners are turned off. First use a clean DAMP cloth to soak up any spills. Remove any food from the burner ports using a small nonabrasive brush like a toothbrush and afterwards wipe up using a damp cloth. For stubborn soils located in the burner ports, use a small gauge wire or needle to clean.
CARE & CLEANING Removing and replacing the lift-off oven door CAUTION The oven door is heavy. For safe, temporary storage, lay the oven door flat with the inside of the door facing down. To remove oven door 1. Open oven door completely (horizontal with floor-Fig. 1). 2. Remove 2 screws located on the inside of the oven door liner (See A Fig. 2). 3. Insert the 2 screws into the door hinge holes located on the side of the hinge arm, one into each hinge (See B Fig. 2). 4.
BEFORE YOU CALL • Solutions to common problems Problem Solution Poor baking results. • Many factors affect baking results. Make sure the proper oven rack position is used. Center food in the oven and space pans to allow air to circulate. Allow the oven to preheat to the set temperature before placing food in the oven. Try adjusting the recipe's recommended temperature or baking time. If you feel the oven is too hot or cool, see “Adjusting oven temperature” section in this Use & Care Guide.
Solutions to common problems • BEFORE YOU CALL Problem Solution Oven smokes excessively during broiling. • Incorrect setting. Follow broil instructions in Setting Oven Controls. • Broiler drawer is open. Be sure broiler drawer is closed. • Meat too close to broil burner. Reposition the broiler drawer rack to provide proper clearance between the meat & the burner. • Meat not properly prepared. Remove excess fat from meat. Cut remaining fatty edges to prevent curling, but do not cut into lean.
MAJOR APPLIANCE WARRANTY Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions. Exclusions This warranty does not cover the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
