Manual

33
CHANGING THE FILTER
Locating the Filters
Your refrigerator is equipped with water
ltering system. The water lter system lters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
The water lter is located at the top right side
of the fresh food compartment.
Ordering Replacement Filters
To order your replacement lters, please visit
our online store at www.frigidaire.com/store,
by calling toll-free at 877-808-4195, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
order extra lters when you rst install your
refrigerator, and that you replace your lters at
least once every six months.
Here is the product number to request when
ordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
Replacing the Water Filter
In general, you should change the water
lter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the lter after a standard amount of water
(200 gallons/757 liters for PureSource
Ultra
TM
) has owed through the system.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lter before reinstalling the refrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certied for cyst reduction may be used on
disinfected waters that may contain lterable cysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
ice and water lter
• Rated service ow - .50 gallons per minute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureSource Ultra
TM
water
lter:
It is not necessary to turn the water supply off
to change the lter. Be ready to wipe up any
small amounts of water released during the
lter replacement.
1 Turn Off the ice maker power switch.
2 Remove the lter by pushing on the end/
face of the lter.
3 Slide the old water lter cartridge straight
out of the housing and discard it.
4 Unpackage the new lter cartridge. Using
the alignment guide, slide it gently into the
lter housing until it stops against the snap-
in connector at the back of the housing.
5 Push rmly until the cartridge snaps into
place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at
the lter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7 After lling one glass of water, continue
ushing the system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button
on the Ice & Water Dispenser control
panel for three seconds. When the display
changes from Red to Green, the status
has been reset.
The PureSource Ultra
TM
ice and
water lter system is tested and
certied to NSF/ANSI Standards
42 and 53 and 401 for the
reduction of claims specied on
the performance data sheet.
More about your Advanced
Water Filter

NOTE
When ordering your replacement lter,
please reorder the same lter type that is
currently in your refrigerator.
FRIGIDAIRE GALLERY