Use and Care Guide

9
IMPORTANT
Should open seal condition exist, try working
the gasket by hand to make sure it is seated
into the channel (see Figure 10).
If the condition still exist, try heating the gasket
with a hair dryer with the door closed. Be care-
ful not to damage the interior door panel or the
gasket by applying too much heat.
If the open seal condition still exist, it may be
necessary to ip the gasket. In this case, remove
the gasket from the door by pulling it out. Rotate
the gasket half a turn (180 degrees). Reinstall
the gasket by inserting the corners rst then
work towards the middle assuring that the dart
is fully seated in the channel.
DOOR REMOVAL/REVERSAL INSTRUCTIONS
(SOME MODELS)
37. Once door gasket has been checked for
open seal condition and corrected (if
necessary), reinstall top hinge cover on
opposite side.
Look for open areas between the
gasket and the cabinet flange.
Gasket should seal against the
cabinet all the way around including top
and bottom
Figure 9
Figure 10