Ice Maker Installation Instructions

1. Unplug refrigerator from electrical outlet.

2. Lift the freezer shelf up and out. Set aside.

3. Remove water inlet and electrical cover, located

on the inside of the unit, by inserting a ﬂathead

screwdriver on left side of opening in the small

cover. Push to the right to disengage the snap.

4. Locate dimples in the freezer liner for screw

placement (a ﬂashlight may help). Align the

shoulder screws with the dimples. Push the

screws to penetrate the freezer liner and drive the

screws in until they are tight against the liner. Use

2 screws on the left side wall, and 3 on the top of

the liner.

To Ceiling

To Wall

Install 5

Shoulder

Screws

5. For a 30" wide refrigerator install the bracket

onto the ice maker. The Ice maker will slide onto

the mounting features on the bracket and snap

into place. The locking feature is located on the

rear of the ice maker.

6. Plug the ice maker in the electrical connector on

the back wall.

Align Water

Inlet

Plug

Electrical

Connector

Make sure the ice maker water channel is under

the water ﬁll tube, and then slide the ice maker

onto the 2 side wall shoulder screws. The ice

maker will snap into place.

Fill Tube is Above IM Water Channel

28" wide refrigerator

Use the ice maker only

Locking

Feature

30" wide refrigerator

Use the bracket with the ice maker