Ice Maker Installation Instructions

4
Ice Maker Installation Instructions (with access cover)
Water
line
Power cord

NOTE
Ensure power cord is aligned with the notch at the
bottom of the access cover and the water line is
located inside the notch at the top right of the cover.
15. Plug connector on water valve wire harness into
the connector above the condenser coil. Install
the water valve clip at the bottom right side of the
unit, and route and attach the water valve harness
into the clip.
CAUTION
Wear gloves and use extreme CAUTION when
handling the access cover.
Plug water tube
into water valve
Remove 8 Screws
12. Remove 8 screws from access cover located at
the bottom rear outside of the unit. Set aside.
13. Place the green water tube to the icemaker into the
bottom outlet of the water valve. The tube must be
pushed into the valve up to the black line marked
on the tube. Check to make sure the tube is in-
stalled correctly.
14. The water valve location has pre-made holes on the
right rear of the unit. The water line should be ori-
ented downward when the valve is installed. Install
the water valve using a ¼" hex head driver, install
the 2 hex head screws. Tighten screws until they are
snug and then tighten an additional ¼ turn.
16. Reinstall the access cover by hooking cover onto
the bottom flange of the cabinet, and then tilt the
cover upward to align with the screw locations on
the cabinet. Install the screws starting with the 2
on the left side, then the right side , finish with the
center screws.
17. Connect the household water line to the water
valve. Follow instructions in Connecting Ice
Maker to Water Supply.