Installation Guide (Ice Maker)

3
Ice Maker Installation Instructions
8. Locate the Ice maker installation label on the
rear outside right top corner of the refrigerator.
Cut the label on the dashed lines, and push flaps
inward until they stick to the unit. See Figure 9.
Align the fill tube key to the slot. Insert the fill
tube with foam pads. Drive the 2 screws to fix the
fill tube against the refrigerator. See Figure 10.
7. Remove the silicone paper on the foam pads.
Stick the ring shaped foam pad to the fill tube.
See Figure 7.
Make sure the end of water fill tube sits within the
water channel of the ice maker. See Figure 11.
9. Slide the ice maker cover onto the shoulder
screws on top of the unit until it locks into place
with a snap. See Figure 12.
Wrap the rectangular foam pad around the fill
tube. See Figure 8.
Figure 7
Figure 8
Cut on dashed lines
and push in on flaps
Figure 9
Figure 10
Figure 12
Figure 11