Complete Owner's Guide

12
DOOR REMOVAL
Door Bottom
A
B
C
Door Closer
Figure 8
Figure 11
8. Repeat steps 1-7 for the freezer door.
9. Lower the refrigerator door in the
opened position on the bottom
hinge pin and close the door (see
Figure 9).
Place the lower hinge cover between
the freezer door and refrigerator
door to keep it level while attaching
the top hinge (see Figure 11).
10. Screw in and tighten the center hinge
pin using an adjustable wrench.
11. Lower the freezer door in the opened
position over the center hinge pin
and close the door (see Figure 10).
1
2
Figure 9
1
2
Figure 10
Door Bearing Reversal For
Freezer and Refrigerator Doors
1. With a flathead screwdriver, pry out
the center hinge bearing plug from
the left side of the refrigerator door
and discard (see Figure 7).
2. Remove the new left side hinge
bearing from the literature bag and
install it on the left side by tapping
it with a hammer until it is flush with
the end cap.
3. Reverse the door handle (see
DOOR HANDLE INSTALLATION
section if applicable).
4. Flip the refrigerator door over and
remove the screw from the door
closer using a Phillips screwdriver
and set it aside (see Figure 8A).
5. Pry out the hinge bearing from the
door with a straight screwdriver (see
Figure 8B).
6. Install the bottom hinge bearing on
the opposite side of the door (see
Figure 8C).
7. Flip the door closer over and install
on the opposite side of the door
(see Figure 8C).
Figure 7