Use and Care Guide

17
SETTING SURFACE CONTROLS
Induction surface cooking zones
To operate an induction cooking zone:
1. Place correctly sized cookware on the cooking zone.
2. Press the On-Off key for the cooking zone.
3. Press the + or - key for the cooking zone (Figure 17)
until you reach the desired setting (refer to the
suggested cooking zone settings in table below.
4. When cooking is complete, turn the induction cooking
zone OFF before removing the cookware.
The cooktop has a sensor to detect cookware in the
cooking zone. The cooking zone will not become active
without proper cookware in position. See
“Cooktop Display
Windows” on page 16.
• The Power Boost (P) setting is only available immedi-
ately after activating a cooking zone by pressing the +
key. The cooktop will remain in Power Boost for up to
10 minutes. After 10 minutes, the cooking zone will
automatically change to the High (H) setting.
• The size and type of utensil used and the amount and
type of food being cooked will influence the setting
needed for best cooking results.
• The Hot Surface indicator light will turn on when heat
is detected in a cook zone. The light will remain on
until the heated surface area has cooled sufficiently.
Figure 17: Induction cooking zone control
NOTE
Frigidaire Induction Recommendations
Temp
Range
Power
Level
Description
Low Low Keep foods warm
Medium
Low
2-4 Start most foods, maintain
water at a boil, pan frying,
searing
Medium 5-6 Continue cooking, poach,
stew
Medium
High
7-8 Continue a rapid boil, fry, or
deep fry
High 9 Start most foods, maintain
water at a boil, pan frying,
searing
Continue cooking, poach,
stew
Power
Boost
P Start heating pans that
contain large amounts of
food or to bring pots of
water to boil
Do not leave empty cookware on an operating cooking
zone. Cookware will heat very quickly and may be
damaged or warped if left on the cooking zone empty.
IMPORTANT
Keep Warm 145°-160°F
Simmer 185 - 200°F