Installation guide

Connecting drain and electrical

Form a "U" shape on the end of the drain hose

with the hose pointed toward the drain. Place the

formed end in a laundry tub or a standpipe and

secure the drain hose with the cable tie (provided

in the enclosure package) to the standpipe, inlet

hose, laundry tub, etc. so the hose does not pull

out from the force of the water.

The standpipe inside diameter must be i-i/4" (3.2 cm)

minimum. There must be an air gap around the drain

hose in the standpipe. A snug hose fit can cause a

siph°ning acti0n: ........................................................................................................................

Check to ensure the power is off at a circuit breaker/

fuse box before plugging the power cord into an outlet,

2 Plug the power cord into a grounded outlet,

Power cord with

3-prong grounded plug

3 Turn on the power at the circuit breaker/fuse box.

4 Read the Use & Care Guide provided with the

laundry center. It contains valuable and helpful

information that will save you time and money,

5 Run the washer through a complete cycle, checking

for water leaks and proper operation,

6 If you have any questions during initial operation,

please review the "Avoid Service Checklist" in your

Use & Care Guide before calling for service,

7 Place these instructions in a location near the

appliance for future reference.

CABL

A wiring diagram and technical data sheet are located

behind the dryer access panel.