Installation guide

13
Unpacking Instructions
1. If foam tub block has been removed,
reinsert it now and tape the lid securely.
2. Carefully cut the front and back corners of
the left side of the remaining cardboard.
3. With help from a second person, carefully
tip the laundry center slightly to the left as
shown in the picture below. Remove the
foam shipping support from the base of the
unit. Save packaging foam for future use.
4. Carefully lower the laundry center to an up-
right position and remove the tape holding
the lid shut. Remove the foam tub block, all
foam inserts, and other tub contents.
5. From the back of the washer, remove the
wire shipping clips securing the drain hose.
6. DO NOT remove the PLASTIC CLIPS which
secure the drain hose to the right side of the
washer back sheet. It helps form a standpipe
to prevent water siphoning.
2
1
UNPACKING LAUNDRY CENTER
7. Carefully move the laundry center to within
four (4) feet of the nal location for the
start of the installation.
Plastic
Clips
Wire
Clip
Front
IMPORTANT
To prevent vibration, possible machine
damage and maximize performance, the
following steps must be completed.

NOTE
If the laundry center is to be transported
at a later date, the tub blocking pad, foam
base and tub support should be retained.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more
than one person move or lift the appliance.