Installation guide

17
Leveling your laundry center
Excessive noise and vibration can be prevented
by properly leveling the laundry center.
1. With the laundry
center within 4
feet (1 m) of its
nal location,
place a level
on top of the
washer lid.
1. Run some water from
the hot and cold faucets
to ush the water lines
and remove particles
that might clog the wa-
ter valve screens and to
determine which faucet
is hot and which is cold
supply
Connecting inlet water
3. Connect the HOT
inlet hose to the
HOT inlet con-
nection on the
washer and the
COLD inlet hose
to the COLD
inlet connection
on the washer.
Tighten by hand
until snug. Then tighten each supply con-
nection another 2/3 turn with pliers. DO
NOT cross thread or over-tighten these
connections.
Rubber Washers
Must Be Present
USE ONLY
NEW HOSES
INSTALLATION INSTRUCTIONS
raise
lower
3. Press down on
alternate corners
and sides and
feel for the
slightest move-
ment. Adjust
the appropriate
leg(s) so the laundry center sits solidly on
the oor on ALL four legs. Keep the leveling
leg extension at a minimum for best perfor-
mance of the washer.
2. Use adjustable
pliers to adjust
the leveling legs
so the laundry
center is level
front-to-rear and
side-to-side, and
stable corner-to-
corner.
2. Check to ensure that
the inlet hoses have the
rubber washer rmly in
place.

NOTE
Hoses are not included with laundry center
purchase. See “Accessories” section for
various inlet hose kits to t your specic
installation.
5. Tighten each
supply connec-
tion another 2/3
turn with pliers.
DO NOT bend,
kink, or pinch
water inlet
hoses.
6. Turn on the
water and check
for leaks.
4. Connect the HOT
inlet hose to
the HOT water
supply and the
COLD inlet hose
to the COLD
water supply.
Tighten by hand
until snug.