Installation guide

Unpacking Instructions
To prevent vibration, possible machine damage and
maximize performance, the following steps must be
comp!eted ..................................................................................................................................................................................
1. If foam tub block has been removed, reinsert it now
and retape the lid securely.
2. Carefully cut the front and back corners of the left
side of the remaining cardboard.
3. With help from a second person, carefully tip the
laundry center slightly to the left as shown in the
picture below. First remove the foam shipping support
to the right side only and then remove the foam
base. Save these items for future use.
4. Carefully lower the laundry center to an upright
position and remove the tape holding the lid shut.
Remove the foam tub block and other tub contents.
date, the tub blocking pad, foam base and tub support
should be retained.
5. From the back of the washer, remove the wire
shipping clip securing the drain hose.
6. DO NOT remove the PLASTIC CLAMP which secures
the drain hose to the right side of the washer
backsheet. It helps form a standpipe to prevent water
siphoning.
Pull out
RIGHT side
ONLY! 7. Carefully move the laundry center to within 4 feet of
the final location for the start of the installation.
person move or lift the appliance.