Installation guide

Electrical connection (non=Canada) = 4 wire cord
4-wire receptacle
(NEMA type 14-30R)
__ _r_Neutra]
t_"1_; 30AMP _%' ))--Ground. t(wH'TE wire)
T NEMA 14-30 4@_ /(GREEN wlre)l
1 Turn off power supply to outlet.
2 Remove the screw securing the terminal block
access cover on the back of the dryer.
3 Install a UL-approved strain relief according to the
power cord/strain relief manufacturer's instructions
in the power cord entry hole below the access
panel. At this time, the strain relief should be
loosely in place.
4 Thread an UNPLUGGED,UL-approved, 30 amp.
power cord, NEMA 14-30 type ST or SRDT,through
the strain relief.
5 Disconnect the internal (WHITE) dryer harness
ground wire from the (GREEN) ground screw next
to the terminal block,
6 Attach the ground (GREEN) power cord wire to the
cabinet with the ground (GREEN) screw, Tighten
the screw securely.
7 Move the internal dryer harness ground (WHITE)
wire to the terminal block and attach it along with
the neutral (WHITE) power cord wire conductor
to the center, SILVERcolored terminal on the
terminal block, Tighten the screw securely.
8 Attach the RED and BLACKpower cord conductors
to the outer, BRASScolored terminals on the
terminal block, Tighten both screws securely,
Do not make a sharp bend or crimp wiring/conductor
at connections,
9 Follow manufacturer's guidelines for firmly securing
the strain relief and power cord.
10 Reinstall the terminal block cover.
GREEN
ground screw_
Move internal ground
(WHITE) wire
(silver) termina} for
4-wire system
BLACK
or RED
power wire
Neutral
WHITE
neut_lwire
BLACK
or RED
power wire