Installation Instructions

ATTACH THE MOUNTING
PLATE TO THE WALL
B3.
•
Read the in structions on the TO P CABINET
TEMPLATE.
• Tape it undern eath the top cabinet.
• Drill th e holes, following the in structions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
Wall
M ounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Bolt End
Installation Instructions
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the moun tin g plate through
the holes designated to go in to drywall and reattach
the toggle wings to
3
⁄4″ ( 19 mm) onto each bolt.
1
2
Place the mounting plate against the wall and
insert the toggle wings into the h oles in th e wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure th e bottom of the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
cen tered un der th e cabinet.
CAUTION: Be careful to avoid pinch in g fingers
between the back of the mounting plate and th e wall.
Tigh ten all bolts. Pull the plate away from th e wall
to h elp tighten th e bolts.
3
4
2
1
Remove and save screw that holds blower motor
to microwave.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
B5.
End B
End A
will exten d far en ough to allow you to adjust
the blower un it.
Back of
M icrow ave
Blow er Motor
Blow er Motor
Screw
Forward
Openings Facing
Carefully pull out the blower unit. Th e wires
Before: Fan Blade
EN-17
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
B4.
You need to drill h oles for th e top support screws and
a hole large enough for the power cord to fit through.
Back of
M icrow ave
Roll th e blower un it 90°
Back of
M icrow ave
3
Before Rotation After Rotation