Installation Instructions

Attach the microwave oven to th e top cabinet.
Installation Instructions
3
MOUNT THE M ICROWAVE
OVEN
B6.
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECO MMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If your cabinet is metal, use th e nylon
grommet aroun d the power cord hole to preven t
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabin et fron t h angs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from
overtightening screws.
Insert a self-aligning screw through top center
cabin et hole. Temporarily secure th e oven by
turn in g the screw at least two full turns after the
threads have engaged. (It will be completely
tigh ten ed later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
8
7
5
Cabinet Front
Cabinet Bottom Shelf
Tigh ten the outer two screws to th e top of the
microwave oven. (While tigh tenin g screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Filler Block
M icrow ave Oven Top
Equivalent
to Depth
of Cabinet
Recess
Insert 2 self-align in g screws
through outer top cabinet
holes. Turn two full turns on
each screw.
packed with the microwave.
Self-Aligning Screw
4
2
Rotate fron t of oven
up again st cabinet
bottom.
NOTE: When mounting the
microwave oven, thread
power cord through h ole in
bottom of top cabinet. Keep
it tigh t th rough out Steps
1–3. Do not pinch cord or
lift oven by pulling cord.
Lift microwave, tilt it
forward, and h ook
slots at back bottom
edge on to four lower
tabs of moun ting
plate.
1
Tigh ten cen ter
screw completely.
Install grease filters. See th e Use &&&&and Care
6
EN-19
IMPORTANT: Remove the cardhoard spacers between
heat shield and door.
IMPORTANT: Do not grip or use the handle
or heat shield during installation. Do not
remove the cardboard spacers between the
heat shield and door.