Complete Owner's Guide

function
Press the “ ” button to switch between degree Fahrenheit and
degrees Celsius.
Timer mode
How to delay startup
How to delay shutdown
Press the “timer off” button, the screen displays “ ”and “H”.
Tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change
delay stop timer at 0.5 hour increments up to 10 hours, then at
1 hour increments up to 24 hours. After 2 seconds, the setting
will be memorized, and the display will show the time remaining
until the unit shuts down.
To cancel the setting, press the “timer off” button again.
You can delay shutdown when the unit is on.
Plug in the unit, so the unit turns to standby.
Press the “timer on” button, the screen will display “ ”and “H”.
Tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change
delay start timer at 0.5 hour increments up to 10 hours, then at
1 hour increments up to 24 hours. After 2 seconds, the setting will be
memorized. The control will count down the time remaining until
startup. The unit will start up in the mode as previously set.
To cancel the setting, press the “timer on” button again.
Fault Code
If the screen displays “P1”, the
should be full.
Refer to the "Drainage Instructions" on Page 16 for more instructions to drain the
successive condensate.
If error repeats, contact your Authorize Frigidaire Service Center.
on the unit water collection tank inside the unit
If the screen on the unit displays “AS”, the room temperature sensor has failed.
Contact your Authorize Frigidaire Service Center.
If the screen displays “ES”, .
Contact your Authorize Frigidaire Service Center.
on the unit the pipe temperature sensor has failed
Operating Instructions