Installation Guide

ManualsBrandsFrigidaire ManualsAir Conditioners12,000 BTU 3-Speed Portable Air Conditioner with Remote for 550 sq. ft.

Installation Instructions

EXHAUSTING HOT AIR

In the Cool Mode the appliance must be placed close to a

window or opening so that the warm exhaust air can be ducted

outside.

First position unit on a flat floor and make sure there’s a minimum

of 12″clearance around the unit, and is within the vicinity of a

single circuit outlet power source.

1. Extend either side of the hose(Fig.1) and screw the hose to

connector A (Fig.2).

2. Extend the other side of the hose and screw it to connector B

(Fig. 3).

3. Install the connector B into the unit (Fig.4).

4. Affix the connector A into the window slider kit and seal.

(Fig.5&6)

The hose can be extended from its original length of 15 up to

59″,but it is the best to keep the length to minimum required.

Also make sure that the hose does not have any sharp bends

or sags.(Fig.7)

″

Vertical

window

Window Slider Kit

Minimum:26.6

″

(67.5cm)

x .

″

Ma mum:48 5 (123cm)

Horizontal

window

Window Slider Kit

Minimum:26.6

″

(67.5cm)

x .

″

Ma mum:48 5 (123cm)

Fig.1

Fig.2

Fig.3

Fig.5

Fig.6

Fig.7

FFPA0822T1、FFPA1022T1

FFPA1222T1、FFPH1222T1

FFPA1422T1、FFPH1422T1

Extend the side of hose

Lock

Slide onto

Fig.4

FFPA0822T1、FFPA1022T1

FFPA1222T1、FFPH1222T1

FFPA1422T1、FFPH1422T1

Summary of content (2 pages)

PAGE 1
Installation Instructions Installation Instructions EXHAUSTING HOT AIR In the Cool Mode the appliance must be placed close to a window or opening so that the warm exhaust air can be ducted outside. First position unit on a flat floor and make sure there’s a minimum of 12″clearance around the unit, and is within the vicinity of a single circuit outlet power source. Extend the side of hose Fig.1 1. Extend either side of the hose(Fig.1) and screw the hose to connector A (Fig.2). 2.
PAGE 2
Installation Instructions Installation Instructions(continued) Installation in a double-hung sash window 1.Cut the foam seals A(adhesive type) to the proper lengths and attach them to the window and stool.(Fig.8) 2.Open the window sash and place the window slider kit on the window stool (Fig.9). Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the width of window. Screw down the two screws on the window slider kit. See Fig.9.