Owner's Guide

Remote Control
Battery Installation and Important Instructions
Cool Only models
Heat and Cool models
Remote Control screen
Timer button
Sleep button
Mode button
Remove the cover at the back of the remote control.
Insert the provided batteries correctly(see the instructions
inside the battery compartment).
Close up the cover.
To replace the old batteries(which have been used up)
with two new R03 “AAA” 1.5V batteries, repeat the
steps above.
Temp/Timer setting button
Swing button
Fan Speed button
RQÂRIIEXWWRQ
Operating Instructions
If the remote control unit is replaced or discarded, the batteries must be removed and disposed of in
accordance with local legislation as they do harm to the environment.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Do not dispose of batteries in fire. Batteries may explode or leak. If the remote control is not used for a
long time, remove the batteries from the remote control.
The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight
or sources of heat.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Point the remote control at the location of the signal receiver.
The remote control must be no more than 16 ft(5 meters)
away from the unit (without obstacles between the remote
control and the unit).
User
Remote Control
Portable AC
Fig.17
Fig.18