Complete Owner's Guide

Timer mode
How to delay startup
Plug in the unit, so the unit turns to standby.
Press the “timer” button, then the Timer indicator and number of hours on the screen will flash.
Tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay start timer at 0.5 hour increments up
to 10 hours, then at 1 hour increments up to 24 hours.
After 5 seconds, the Timer indicator and the display stop flashing. The control will count down the time
remaining until startup.
The unit will start up in the mode as previously set.
To cancel the setting, press the “timer” button again. The timer indicator will switch off.
The timer facilitates the user to delay the unit startup or shutdown.
ECO mode
Press the "fan speed" button to choose the fan speed according to the illumination of the fan speed indicator.
You can choose the “hi”, “med”, “low”, or “auto” fan speed setting.
Press the “ ” or “ ” button to choose the temperature you want.
In few seconds after you set the temperature, the screen will display the room temperature.
Note: The unit will run in energy saver(ECO) mode when used for the first time. In this mode, the fan
will continue to run for 3 minute after the compressor shuts off. The fan then cycles on for 90
seconds at 10 minute intervals until the room temperature is above the set temperature, at which
time the compressor turns back on.
Press the “mode” button until the ECO mode indicator lights.
Operating Instructions