Installation Guide

ManualsBrandsFrigidaire ManualsAir Conditioners12,000 BTU Window-Mounted Room Air Conditioner

READ BEFORE INSTALLING UNIT

BL Window Mounting (10,000 - 12,000 BTU)

Installation Instructions

Before installing, the top rail must be assembled on the unit.

Top Rail Hardware

Qty.

Top Rail

Drill (If pilot holes are needed)

Mounting Hardware Qty.

(For Vinyl-Clad windows)

NOTE:

the best way to store unit during winter, or when not

in use.

(For Wooden windows)

Top Rail

Fig. C

weather seals

window sash seal foam 1

be exposed:

Carefully read the installation manual before beginning.

INSTALLATION WARNINGS AND CAUTION

Fig. B

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended

period of time.

The top rail on your unit may already be installed. If not,

follow the steps below.

66129926563

Summary of content (4 pages)

PAGE 1
Installation Instructions READ BEFORE INSTALLING UNIT BL Window Mounting (10,000 - 12,000 BTU) INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. be exposed: Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended period of time. NOTE: Mounting Hardware Qty. 7 the best way to store unit during winter, or when not in use.
PAGE 2
Installation LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear. This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper panel for each side.
PAGE 3
Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6B FIG. 6A INSIDE OUTSIDE INSIDE OUTSIDE Wooden Windows Vinyl-Clad Windows Extend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Clad windows). FIG. 7A FIG.
PAGE 4
Installation NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by window itself. Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 11). FIG. 10 FIG. 11 FOAM SEAL Check that air conditioner is tilted back about 1/4" (tilted about 2º to 4º downward to the outside, see FIG. 12A & FIG. 12B).