Installation Instructions READ BEFORE INSTALLING UNIT OPP Window Mounting BTU) INSTALLATION WARNINGS AND CAUTION * Careful read the Installation manual before beginning ® Follow each step es shown. # Observe alf focal, state, and national electrical codes and by qualified, fostered. authorized personnel early. # Pay attention to danger ard safety notices. To avoid isk of personal Injury.
Installation LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Tap Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/167) ‘This is necessary for proper condensed water finalization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place rit on floor, a bench or a table. There is a Left and Right side Filler Panels be sure to use the proper panel for each side.
Installation Keep a firm grip or the air conditioned, carefully place the unit info the window opening so the bettor of the ai conditioner frame is again ha window sil (FIG, BA & FIG. 68). Carefully close tvs window biotin the top rai of the unit FIG. INSIDE INSIDE OUTSIDE OUTSIDE Wooden Windows Vinyl-Clad Windows Extend the side panels out against the window frame (FIG. TA for wooden windows), (FIG. 78 for Vinyl-Clad FIG.
Installation Ta secure lows sash in place. attach tight angle sash lock with 1/2" (12. 7mm) sower as Shawn (FIG. 10), FE NOTE 115 difficult © fork the windows with the sash look for Vinyl. Glad winos, 51 you oan usa lock by widow itself. 8 Cut foam window seal and insert iL into the space between the upper and wore sashes (FIG. 11) FIG. 10 Fie. 11 i FOAM SEAL Check that air conditioner is rite back about 1/2” to 4. FIG. 12A & FIG. 128).