Wiring Diagram/Installation Instructions

ManualsBrandsFrigidaire ManualsAir Conditioners6,000 BTU 115-Volt Window-Mounted Mini-Compact Air Conditioner with Full-Function Remote Control in White

READ BEFORE INSTALLING UNIT

BK Window Mounting (5,000 - 6,000 BTU)

Installation Instructions

Before installing, the top rail must be assembled on the unit.

Top Rail Hardware

Qty.

Top Rail

Drill (If pilot holes are needed)

Mounting Hardware Qty.

(For Vinyl-Clad windows)

NOTE:

the best way to store unit during winter, or when not

in use.

(For Wooden windows)

Top Rail

Fig. C

weather seals

window sash seal foam 1

be exposed:

Carefully read the installation manual before beginning.

INSTALLATION WARNINGS AND CAUTION

Fig. B

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended

period of time.

66129926906

insulation panel

ruler

Fig. B

Summary of content (5 pages)

PAGE 1
Installation Instructions READ BEFORE INSTALLING UNIT BK Window Mounting (5,000 - 6,000 BTU) INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. be exposed: Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended period of time. NOTE: Mounting Hardware Qty. 7 2 (For Wooden windows) the best way to store unit during winter, or when not in use.
PAGE 2
Installation LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear. This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper panel for each side.
PAGE 3
Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6B FIG. 6A INSIDE OUTSIDE INSIDE OUTSIDE Wooden Windows Vinyl-Clad Windows Extend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Clad windows). FIG. 7A FIG.
PAGE 4
Installation Measure the width of the inner side curtain with the provided ruler, as shown (FIG. 10). Mark a line on the provided insulation panel according to the measured width, then cut out the insulation panel along the line, as shown (FIG.11). Peel off the protecting film behind the insulation panel and stick the panel on the side curtain, as shown (FIG.12). Repeat these instructions for the other side. L L 2 3 4 5 4 3 2 1 1 6 7 8 9 10 11 FIG. 10 L FIG. 11 FIG. 12 (FIG. 13).
PAGE 5
Installation 10 Check that air conditioner is tilted back about 1/4" to 1/2" (tilted about 2º to 4º downward to the outside, see FIG. 15A & FIG. 15B). After proper installation, condensate should not drain from the overflow drain hole during normal use, correct the slope otherwise. FIG. 15A 2º to 4º FIG.