Installation Instructions

ManualsBrandsFrigidaire ManualsAppliancesFFRG4120SW 6.7 cu. ft. Free-Standing Gas Dryer - White

I NSTALLATI ON I NSTRUCTI ONS

4-wire receptacle

(NEMA type 14-30R)

Neutral

(WHITE wire)

30 AMP

NEMA 14-30

Ground

(GREEN wire)

Electrical connection (non-Canada) - 4 wire cord

WARNI NG

ELECTRI CAL SHOCK HAZARD

Failure to disconnect power source before servicing could

result in personal injury or even death.

WARNI NG

ELECTRI CAL SHOCK HAZARD

Do not make a sharp bend or crimp wiring/ conductor at

connections.

Move internal ground (WHI TE)

wire to neutral (center) terminal

for 4-wire system.

GREEN

ground screw

WHITE

neutral wire

BLACK

or RED

power wire

BLACK

or RED

power wire

GREEN

ground wire

Neutral

terminal

Terminal

cover

1 Turn off power supply to outlet.

2 Remove the screw securing the terminal block access

cover in the upper corner on the back of the dryer.

3 Install a UL-approved strain relief according to the

power cord/ strain relief manufacturer’s instructions in

the power cord entry hole below the access panel. At

this time, the strain relief should be loosely in place.

4 Thread an UNPLUGGED, UL-approved, 30 amp. power

cord, NEMA 14-30 type ST or SRDT, through the strain

relief.

5 Disconnect the internal (WHITE) dryer harness ground

wire from the (GREEN) ground screw next to the

terminal block.

6 Attach the ground (GREEN) power cord wire to the

cabinet with the ground (GREEN) screw. Tighten the

screw securely.

7 Move the internal dryer harness ground (WHITE)

wire to the terminal block and attach it along with the

neutral (WHITE) power cord wire conductor to the

center, SILVER colored terminal on the terminal block.

Tighten the screw securely.

8 Attach the RED and BLACK power cord conductors to

the outer, BRASS colored terminals on the terminal

block. Tighten both screws securely.

9 Follow manufacturer’s guidelines for ﬁ rmly securing the

strain relief and power cord.

10 Reinstall the terminal block cover.