Complete Owner's Guide
26
TROUBLESHOOTING
Visit our web site at
www.frigidaire.com
1-800-374-4432 (United States)
1-800-265-8352 (Canada)
CONCERN CAUSE SOLUTION
AUTOMATIC ICE MAKER
Ice maker is not
making any ice.
• Ice maker wire signal arm is
in the “up” or OFF position.
• Ice maker has small cube
caught in mechanism.
• Saddle valve on cold water
pipe is clogged or restrict-
ed by foreign material.
• Move wire signal arm to the “down” or ON
position (side mounted).
• Remove small cube from ice maker. The
ice and water lter cartridge may be
clogged. Replace lter cartridge.
• Turn o household water line valve.
Remove valve. Ensure that valve is not
a self-piercing saddle valve. Clean valve.
Replace valve if necessary.
Ice maker is
not making
enough ice.
• Ice maker is producing
less ice than you expect.
• Check to see if water
dispenser is dispensing
slower than normal.
• Freezer control is set
too warm.
• Side mounted ice maker should produce 4
to 4.5 pounds (approximately 4 quarts) of
ice every 24 hours.
• If it is, replace the ice and water
lter cartridge.
• Set freezer control to colder setting to im-
prove performance of the ice maker. Allow
24 hours for temperature to stabilize.
Ice maker will
not stop mak-
ing ice.
• Ice maker wire signal arm
is being held down by
some item in the freezer.
• Move item and release wire signal arm.
Remove any ice cubes that are frozen
together over the wire signal arm.
Ice cubes are
freezing to-
gether.
• Ice cubes are not being
used frequently enough.
• Ice cubes are hollow
(partially frozen cubes
with water inside).
• Freezer control is set
too warm.
• Remove ice container and discard ice from
container. Ice maker will produce fresh supply.
• The ice and water lter cartridge may be
clogged. Replace lter cartridge.
• Set freezer control to colder setting. Allow
24 hours for temperature to stabilize.
DISPENSER (Ice & Water)
Dispenser will
not dispense ice.
• Dispenser lock out
is engaged.
• There is no ice in the bin
to be dispensed.
• The refrigerator doors are
not completely closed.
• Dispenser paddle has
been pressed too long
and the dispenser motor
has overheated.
• Press and hold control lock for 3 seconds.
• See the “Ice maker is not making any ice”
section above.
• Be sure the refrigerator doors are com-
pletely closed.
• The motor overload protector will reset in
about three minutes and then ice can
be dispensed.
Ice dispenser is
jammed.
• Ice has melted and
frozen around auger
due to infrequent use,
temperature uctuations,
and/or power outages.
• Ice cubes are jammed
between ice maker and
back of ice container.
• Remove ice container, thaw, and empty
the contents. Clean container, wipe dry,
and replace in proper position. When new
ice is made, dispenser should operate.
• Remove ice cubes that are jamming the
dispenser.