Complete Owner's Guide

22
Locating the Filter
Your refrigerator is equipped with a water ltering
system. The water lter system lters all dispensed
drinking water, as well as the water used to
produce ice.
Water Filter
The water lter is located at the top right side of
the refrigerator compartment.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certied for cyst reduction may be used on
disinfected waters that may contain lterable cysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
and PureSource 3
TM
ice and water lter
• Rated service ow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure:
30 pounds per square inch
To replace your PureSource 3
TM
water lter:
It is not necessary to turn the water supply o
to change the lter. Be ready to wipe up any
small amounts of water released during the
lter replacement.
1. Turn O the ice maker.
2. Remove the lter by pushing on the end/face
of the lter.
3. Slide the old water lter cartridge straight out
of the housing and discard it.
4. Unpackage the new lter cartridge. Using
the alignment guide, slide it gently into the
lter housing until it stops against the snap-in
connector at the back of the housing.
5. Push rmly until the cartridge
snaps into place (you should hear a
click as the cartridge engages the
snap-in connector).
6. Press a drinking glass against the water
dispenser while checking for any leaks at the
lter housing. Any spurts and sputters that
occur as the system purges air out of the
dispenser system are normal.
7. After lling one glass of water, continue
ushing the system for about four minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter button on
the Ice & Water Dispenser control panel for
three seconds. When the display changes from
“Red” to “Green,” the status has been reset.
Ordering Replacement Filters
To order your replacement lters, please visit our
online store at www.frigidaire.com/store, by calling
toll-free at 877-808-4195, or by visiting the dealer
where you purchased your refrigerator. Frigidaire
recommends that you order extra lters when you
rst install your refrigerator, and that you replace
your lters at least once every six months.
Here are the product numbers to request when
ordering:
PureSource Ultra
TM
Water Filter
Part# ULTRAWF
PureSource 3
TM
Water Filter
Part #WF3CB
Replacing the Water Filter
In general, you should change the water lter every six
months to ensure the highest possible water quality.
Water Filter Status on the user interface prompts
you to replace the lter after a standard amount of
water (200 gallons/757 liters for PureSource Ultra
TM
and PureSource 3
TM
) has owed through the system.
If your refrigerator has not been used for a period of
time (during moving for example), change the lter
before reinstalling the refrigerator.
Filter Cartridge
The PureSource 3
TM
ice and water
lter system is tested and certied to
NSF/ANSI Standards 42 and 53 for
the reduction of claims specied on
the performance data sheet.
More about your Advanced Water
Filter

NOTE
If your refrigerator is equipped with a PureSource
3
TM
water lter, it can be replaced with a
PureSource Ultra
TM
water lter. Replacing your
PureSource 3
TM
water lter with a PureSource
Ultra
TM
water lter removes more potential
contaminants as tested by NSF. The contaminants
or other substances removed or reduced by this
water lter are not necessarily in all users’ water.
FILTER REPLACEMENT

NOTE
If your refrigerator is equipped with a PureSource
Ultra
TM
water lter, it must be replaced with
PureSource Ultra
TM
water lter ULTRAWF.
The PureSource Ultra
TM
ice and
water lter system is tested and
certied to NSF/ANSI Standards 42 and
53 for the reduction of claims specied
on the performance data sheet.