Use and Care Guide

8
DOOR REMOVAL INSTRUCTIONS - STYLE 1
Door
Water
Line
Tubing
Screws
Hinge
Assembly
To Remove Freezer Door:
1. Disconnect water line coming from lower
hinge of freezer door at connection
located under front of freezer: Press outer
ringagainstfaceoftting,thenpullto
remove tube.
2. Remove top hinge cover screw on freezer
door and remove cover.
3. Disconnect wiring harness connector plug
attophinge:placeyourthumbsonat
sides of each connector and bend both
partsbackandforth,thenwithrmgrasp,
pull both pieces apart.
4. Trace around hinge with soft lead pencil.
This will make it easier to realign doors
when they are replaced.
5. Remove top hinge, allowing wiring harness
to pull through hinge and lift freezer door
off of bottom hinge pin. Lay door down
attoavoidkinkingwaterline.
6. Remove bottom hinge, if necessary.
7. Reverse this procedure to reinstall freezer
door.
When both doors have been reinstalled,
connect water line by inserting tube and push
untilmarktouchesfaceoftting,replacetoe
grille and plug in electrical power cord. Turn
both temperature controls to center position.
Adjust settings as necessary.
To Disconnect
1. Press outer ring against face of
fitting
2. Pull to
remove tube
Insert tube and push until mark
touches face of fitting
To Connect