Installation Instructions

10
Trim Kit Installation Instructions
1. Install the 1” x 1” x 84” long stuffer seal
between the wall sleeve and the unit. A
flat-bladed screwdriver or putty knife is
recommended.
2. Assemble the trim frame by inserting the
top and bottom pieces into side pieces
and snapping into place.
Energy Saving Suggestion: In order to reach the maximum energy saving and comfort, it is recommended to
use an appropriately sized cover to provide additional insulation and air sealing when the unit is not in use
during the off-season. The size of the unit front panel is 24.2” x 14.6” x 2” (W x H x D), so the size of the cover
should be 0.3”~0.5”larger than each dimension of the unit front panel to facilitate satisfactory fit.
3. Pull the cord through the trim frame and
slide the trim over the unit until flush with
the wall.
NOTE: For larger sleeves, an accessory kit
is available (EA120T)
Installation Instructions