Installation instructions

7
NOTE
Hoses are not included with washer purchase. See
“Accessories” section for various inlet hose kits to fi t your
specifi c installation.
INSTALLATION INSTRUCTIONS
a
b
c
d
Leveling your washer
Excessive noise and vibration can be prevented by properly
leveling the washer.
1 With the washer within 4 feet (1 m) of its fi nal location,
use a carpenter’s level to level your washer front-to-
back and side-to-side. For front-to-back leveling, place
edge of the level fl ush to the front panel. For side-to-
side leveling place the edge of the level fl ush to the
side panel.
2 Use adjustable pliers to adjust the front leveling legs so
the washer is level front-to-rear and side-to-side, and
stable corner-to-corner.
3 Press down on alternate corners and sides and feel for
the slightest movement. Adjust the appropriate front
leg(s) so the washer sits solidly on the fl oor on ALL four
legs. Keep the leveling leg extension at a minimum for
best performance of the washer.
1 Run some water from the hot and cold faucets to fl ush
the water lines and remove particles that might clog
the water valve screens and to determine which faucet
is hot and which is cold supply.
Connecting inlet water
2 Connect the HOT inlet hose to the HOT inlet connection
on the washer and the COLD inlet hose to the COLD
inlet connection on the washer. Tighten by hand until
snug. Then tighten each supply connection another
2/3 turn with pliers. Do not cross thread or over-
tighten these connections.
3 Connect the HOT inlet hose to the HOT water supply
and the COLD inlet hose to the COLD water supply.
Tighten by hand until snug. Then tighten each supply
connection another 2/3 turn with pliers. Do not bend,
kink or pinch water inlet hoses.
4 Turn on the water and check for leaks.
RUBBER WASHERS
MUST BE PRESENT
USE ONLY
NEW HOSES
raise
lower
a
g
b
c
d
e
f
BLUE
(COLD)
RED
(HOT)