Wiring Diagram

Troubleshooting Tests
Test
Number
Problem Solution
Test 1
The unit doesn’t start.
-Check the fuse or reset the circuit breaker.
-Make sure your washer is plugged in.
-Make sure the lid is closed.
-Make sure the water source faucets are open.
-Make sure to press the Start/Pause button to start your washer.
-
-
-Before your washer starts to fill, it will make a series of clicking
noises to check the lid lock and go a quick drain.
Make sure Control Lock is not activated.
Check if a Delay Start is set.
Test 2
No water or not enough water.
Detergent / Softener remains in its box
after the wash cycle is completed.
- Turn both faucets on fully.
-
-Straighten the water inlet hoses.
-Disconnect hoses and clean the screens. Hose filter screens
may be clogged.
Check if the water pressure is in required range.
Test 3
Vibrates or is too noisy.
- Make sure your washer is set on a level surface. If the surface is
not level, adjust your washer’s feet to level the appliance.
-Make sure your washer is not touching any other object.
-Make sure the laundry load is balanced.
During the spin cycle if clothes are piled to one side of the
basket, it will stop due to a out of balance condition. The unit will try to
solve the problem automatically. If the washer can't solve the
problem in three attempts, you should redistribute the clothes and
make theme as even as possible manually
Test 4
Stops
-Plug the power cord into a live electrical outlet.
-Check the fuse or reset the circuit breaker.
-Close the lid and press the Start/Pause button to start your
washer. For your safety, your washer will not spin unless the lid
is closed.
-Before your washer starts to fill, it will make s series of clicking
noises to check the lid lock and do a quick drain.
-There may be a pause or sock period in the cycle. Wait and it
may start.
-Check the screens on the inlet hoses at the faucets for
obstructions. Clean the screens periodically.
Test 5
Lid locked or not . opening
- .
It may take a few moments for the lid lock to disengage.
Press the Start/Pause button to stop the washer.
Test 6
Does not drain or spin.
- Straighten the drain hoses. Eliminate kinked hoses. If there is a
drain restriction, call for service.
-close the lid and press the Start/Pause button. For your safety,
your washer will not spin unless the lid is closed.
-Check the height of drain hose end.
Washer Troubleshooting Tests, continued
4