All about the Use & Care of your Wine Cooler TA B L E O F C O N T E N T S Important Safety Instructions..................................2 Temperature Controls.............................................7 Installation............................................................4 Features................................................................8 Door Reversal Instructions......................................5 Care and Cleaning.................................................
SERIAL/MODEL #’S - Important Safety Instructions Read and Save These Instructions This Owner’s Guide provides specific operating instructions for your model. Use your Wine Cooler only as instructed in this guide. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.
Important Safety Instructions WARNING Electrical Information WARNING Child Safety The wine cooler must be plugged into its own dedicated 115 Volt, 60 Hz., 15 Amp, AC only electrical outlet. The power cord of the appliance is equipped with a three-prong grounding plug for your protection against electrical shock hazards. It must be plugged directly into a properly grounded three prong receptacle. The receptacle must be installed in accordance with local codes and ordinances.
Installation This Use & Care Guide provides general operating instructions for your model. Use the appliance only as instructed in this Use & Care Guide. Before starting the wine cooler, follow these important first steps. Location • Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an adapter plug. • For optimal performance, it is recommended that you install the wine cooler where the ambient temperature is between 70 and 78 degrees fahrenheit.
INSTALLATION Reversing the door swing The glass door can be opened from left to right and vice versa. Should you desire to change the opening direction, please follow these instructions. NOTE All parts removed must be saved to do the reinstallation of the door. Step 11:Loosen the bolt� and bottom hinge�ˈthen replace the parts on the left and right sideˈthen assemble the parts,see chart 6. 1. Remove top cap. Remove the three screws that hold the upper hinge (right side) to the top of the cabinet.
INSTALLATIONChart 2 ENERGY SAVING TIPS Step 7:Remove the bolt on the bottom of the door by screwdriver�(see chart 3) Step 8:Remove the screw� and the block �,then set them on the left side.(see chart 3) • Stop bracketľ Ľ Bushingļ Fig. 6 Chart 3 axis� make from the hole to left hole(see and fixStep the 9:Change top hingethe on hinge the door,to theright door level,see chart 8. chart 4) Step 14:Check the sealing of the door,then refit the parts �ǃ�. Fig.
TEMPERATURE CONTROLS • • The default temperature for the wine cooler is 54°F (12°C). The temperature after power failure will be the temperature set before the power failure. To prolong the life of compressor, please wait for at least 5 minutes before the wine cooler is restarted after power failure. Failure display • If “E” and “F” are displayed, please contact local service personnel for repair. • If the temperature in the cooler is too low, it will display “L”.
International or other national or regional standards: GB-T 23777-2009 Wine Cooler UL 250 BULLETINS-2003 U.S.A. household fridge safety requirements International or other national or regional standards: Electromagnetic compatibility (EMC) - Limits Limitation of emission of harmonic currents in low-voltage power supply UL 250 BULLETINS-2003 U.S.A.
CARE AND CLEANING Cleaning the wine cooler • • Before cleaning, turn the temperature control to OFF, unplug the wine cooler and remove the bottles. Clean your wine cooler once every two months. Inside: Wash inside surfaces of the wine cooler with a solution of two tablespoons of baking soda in one quart (1.136 liters) warm water. Rinse and dry. Wring excess water out of the sponge or cloth when cleaning in the area of the controls, or any electrical parts.
Before You Call 1-800-944-9044 (United States) Visit our web site at www.frigidaire.com. 1-800-265-8352 (Canada) PROBLEM CAUSE CORRECTION WINE COOLER OPERATION Wine Cooler does not run. • • • • • Wine Cooler runs too much or too long. • • • • • • • Wine cooler is plugged into a circuit that has a ground fault interrupt. Temperature control is in the OFF position. Wine cooler may not be plugged in, or plug may be loose. House fuse blown or tripped circuit breaker. Power outage.
Before You Call (continued) PROBLEM CAUSE CORRECTION SOUND AND NOISE (continued) Longer sound levels when compressor comes on. • Wine Cooler operates at higher pressures during the start of the ON cycle. • This is normal. Sound will level off or disappear as refrigerator continues to run. Fan runs when room temperature is below 45°. • Exterior thermostat has activated the heater or fan. • This is normal. Popping or cracking sound when compressor comes on.
major appliance warranty Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions. Exclusions This warranty does not cover the following: 1.