Complete Owner's Guide

Operating Instructions

(continued)

2. To turn the unit on, press the ON/OFF button. The unit will run in the factory setting of Auto mode. In this mode, the

unit will automatically set a comfortable humidity and fan speed according to the indoor environment.

Note: In this mode, set humidity and fan speed can not be changed manually and the display will show actual room humidity.

Allow the unit to reach room temperature before operating.

To begin operating the dehumidifier, follow these steps:

1. Plug the power cord into a properly grounded 115 volt AC outlet.

If the "BUCKET FULL" light is flashing, remove the bucket and re-install to reset the float switch.

NOTE:

Unit must be upright for one hour prior to operating.

NOTE:

3. To use Quiet mode, press the Mode button to choos Quiet mode. The unit will run in low fan speed for the whole time and

the unit will automatically set a comfortable humidity according to the indoor environment.

Note: In this mode, set humidity and fan speed can not be change manually and the display will show actual room humidity.